0
If your 1985 Toyota pickup is hard to crank after it’s hot, it could be due to several issues, such as vapor lock, a failing starter motor, or a weak battery. Vapor lock can occur when fuel vaporizes in the fuel lines, preventing the engine from starting easily. Additionally, a hot starter may draw more current and struggle to turn over the engine. It’s advisable to inspect the fuel system, battery, and starter to diagnose the problem accurately.
What else can I help you with?
How hard is it to change the rear main seal in my 1992 Toyota pickup 3.0 V 6?
How hard is it to change the rear main seal in my 1992 toyota pickup , with the 3.0 V6
How do you remove a shift knob on a 1994 Toyota pickup?
Twist, hard!
Hard steering on 1986 Toyota pickup 22r?
Try changing the ball joints
Why is your 92 Toyota pickup hard to put in gear?
It probably needs a new clutch.
How do you replace brake pads cylinders and rotors on a 1989 Toyota 4x4 pickup?
you have to take off the hubs and you need crazy hard to find tools
Hard start f-250 2006 crank crank and crank and it will start?
plugs wires
Where is the location of the horn relay in a 1994 Toyota pickup?
I have a 1992 Toyota pickup, Had a HARD time finding the horn relay myself. The horn relay on my 1992 Pickup is located on the drivers side, to the right (or towards the front of the truck) of the small fuse block that has an access panel door on the kick panel, you have to remove the kick panel to see the relay, in my case it was just unplugged, plugged it back in and horn now works. The relay has printing on it and it says "HORN RELAY" Good luck! Laterz, Len P :) I would like to find the Fuel Pump relay on my 1992 Toyota pickup.
What are the release dates for Hard - 1985?
Hard - 1985 was released on: USA: 1985
How do you remove a crank shaft pullie from a 98 Toyota camary?
You have to get a pulley puller of the appropriate size. Without a pulley you have no chance safely to remove it. Be careful do not deform the pulley it's not that hard as you can think.
Is the crank pulley bolt on a 2000 Toyota t100 left handed thread?
No mention of it, they are just hard to slacken , accepted method of removal is one day hire of air compressor and impact wrench.
How do you take off the window handle from a 1997 Chevy 1500 pickup?
There is a special tool that is designed for this but, if you have patience, you can get away with a couple of screw drivers. There is a wire clip that needs to be removed at the base of the crank. It's a little hard to get to but, if you push the door panel in a little, you should be able to get to it. Disconnect the wire clip and the crank should pull off.
Where is blower motor located on 1995 Toyota Tacoma pickup and is it hard to replace myself?
underneath the dash under the glove box area and only held on by 3 star screws took me about 3 minutes to change it
