0
The inlet size of the exhaust muffler for a 2005 Honda Accord EX is typically around 2.25 inches (57 mm). However, it's always a good idea to verify with specific aftermarket parts or consult the vehicle's service manual for precise measurements, as variations may exist based on engine configuration or modifications.
What else can I help you with?
What is the right size inlet valve for a Honda cbx 1000?
Hi, inlet is 25mm and exhaust is 22mm
What is the valve clearance on a Honda gc160?
Valve clearance for a Honda GC160 engine; Inlet 0.15 +/- 0.04mm Exhaust is 0.20 +/- 0.04mm
Could someone tell me the valve sizes on1980 cb900f Honda?
26mm inlet 22.5 exhaust
How do you set the tappets on a Mitsubishi 6d14 engine?
With No1 cylinder at TDC adjust the following valve clearances, No. 1, inlet and exhaust No. 2, inlet No. 3, exhaust No. 4, inlet No. 5, exhaust Then turn the crankshaft 1 full turn so that No 6 cylinder is at TDC and adjust the following valve clearances, No2. , exhaust No. 3, inlet No. 4, exhaust No. 5, inlet No. 6 inlet and exhaust. Both inlet and exhaust clearances ar 0.4 mm with engine cold. This info is from the original service manual
What is the valve clearance settings for a Honda acty 1986?
Cold settings are Inlet 0.12-0.18 mm Exhaust 0.15-0.18 mm
What cause a 1994 Honda Accord to stall when low on gas?
The primary cause of a 1994 Honda Accord to stall when the gas is low is water or contaminants in the gas tank. When the gas level is low, the fuel pickup will pull contaminants that would otherwise be floating well away from the inlet.
Is there a gasket between the inlet to the muffler and the B pipe on a 1989 Honda civic lx 4 door?
only if you put one there! there should be an exhaust donut there,.
Where is 2004 Honda cr-v oxygen sensor 1 location?
I believe you'll find it at the point where the exhaust pipe fits into the inlet of the catalytic converter.
Inlet exhaust valve what is it?
An inlet and exhaust valves are two separate things. The inlet valve lets the fuel/ air ,ix into the cylinder. The exhaust valve opens to let the pressure out after the mix has burned, releasing the gasses. Then the process starts over again.
What is the valve clearance on a 81 gold wing gl 1100?
Manual for the 1979-81 Honda Goldwing 1100 states "inlet 0.1mm, exhaust 0.13mm" hope that helps, bye.
What is the Difference between inlet valve and exhaust valve?
the difference is that the inlet valve takes air (oxygen) from surrounding in order to combution of fuel which result in blast by air fuel mixture and piston rotates while the exhaust gases removed from the exhaust valve.again the inlet valve opens first before blast and exhaust valve opens afterward
Do i use a 2.25 inlet on a 2.5 exhaust tip?
yes
