0
What else can I help you with?
What size socket needed to remove starter bolts on a 1998 Honda Accord?
14mm
What is the spindle nut on 2000 ford focus rear drum brakes?
Nut you see after you remove the dust cover, in the middle of the drum, 30mm socket needed to remove
What size wrench is needed to remove the brake caliper bolts on a 1991 Honda Accord?
use an Allen wrench not a socket or open or box wrench.
What size socket do you need to remove the spindle nut on a 2003 Sonoma 4x4?
1 3/8 inch deep socket
What size socket is needed for the axle nuts on a 96 Honda accord?
36mm
What size socket is required to remove the hub nut on 2006 Honda Accord se?
36mm.
What size socket is needed for a 2004 Honda Accord knock sensor?
To remove the knock sensor on a 2004 Honda Accord, you typically need a 10mm socket. It's important to ensure you have a ratchet and an extension for better reach, as the sensor is located in a tight space. Always consult the vehicle's service manual for specific details and recommendations.
What size Allen socket is needed to remove caliper bolt on a 2004 Escape?
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
What tool do you need to remove the calipers from a 2007 Chevy Malibu ls?
15 mm socket and ratchet for the caliper to bracket. if not it is a 13 mm socket and ratchet. the bracket to spindle is 18mm socket and ratchet
How do you remove the rear window wiper spindle on your Jaguar x type?
To remove the rear window wiper spindle on a Jaguar X-Type, first, ensure the wiper is in the "off" position. Then, gently pry off the plastic cover that conceals the spindle nut. Use a socket wrench to remove the nut securing the spindle, and carefully pull the spindle out from its housing. Finally, check for any clips or connectors that may need to be disconnected before fully removing the spindle.
What size socket needed to remove spindlenuts on a 2007 ford escape?
To remove the spindle nuts on a 2007 Ford Escape, you'll typically need a 32mm socket. It's important to ensure that you have a sturdy ratchet or breaker bar, as these nuts can be quite tight. Always check your vehicle's manual or a repair guide for confirmation and specific torque specifications.
How do you remove a brake rotor in 1988 Chevy four wheel drive?
1.get the tire off 2.remove the locking hubs 3.this is where you are going to need a special spindle nut socket in order to remove the spindle nuts (where to get one of those im not sure but i think Napa or Autozone would sell something like that.) 4.after you get the spindle nuts off you remove the calipers
