0
What else can I help you with?
What size socket is needed to remove spindle nut for 1997 Honda accord?
36mm
What tools do are needed to remove the starter on a 1985 ford crown Victoria LTD?
a ratchet, 3/8" socket (for the power cable), and either 1/2" or 5/8" socket for the 2 bolts that hold the starter in place.
What size wrench is needed to remove the brake caliper bolts on a 1991 Honda Accord?
use an Allen wrench not a socket or open or box wrench.
What size socket is needed for the axle nuts on a 96 Honda accord?
36mm
What size socket is required to remove the hub nut on 2006 Honda Accord se?
36mm.
How do you change a starter in a 1991 Acura Integra?
you will need: 12mm socket 10mm socket 14mm socket ratchet 3" extension unhook battery power remove power cable in top of starter remove signal wire on starter remove the 2 14mm bolts from top and bottom of starter threaded in and through trans pull starter out and put new on in reverse this procedure starter is located a little behind and directly under the distributor on pass side of engine bay on trans
What size Allen socket is needed to remove caliper bolt on a 2004 Escape?
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
What size socket is needed for a 2004 Honda Accord knock sensor?
To remove the knock sensor on a 2004 Honda Accord, you typically need a 10mm socket. It's important to ensure you have a ratchet and an extension for better reach, as the sensor is located in a tight space. Always consult the vehicle's service manual for specific details and recommendations.
Crankshaft sensor location on Chevy Avalanche?
It's easy its just above the starter remove the starter with 1/2" socket your crank sensor is right there one 10mm socket
How do you replace starter on 1998 Harley fat boy?
disconnect the battery, pull the primary cover and remove the jack shaft, You will need a 1/4 Allen socket to get to the starter bolts. remove battery pos cable from starter and remove
What tool do you need to remove a starter 05 Pontiac grand am?
To remove the starter in your 05 Pontiac Grand Am you will need a socket wrench. You will also need a car jack to lift the car so you can reach the starter.
How do you change a starter in a 2000 Oldsmobile intrigue what size wrenches do you need?
I just changed the starter in my 2000, 3.5L, V6, Oldsmobile Intrigue. I am going from memory here but the sizes should get you fairly close. The starter is held on with 2 bolts. I used a 13mm (or maybe 11mm or 12mm) socket with a 12" extender to remove the bolts. There are 2 wires attached to the starter. I used an 8mm socket (but a deep socket, the kind of socket that is ~3" long) to remove the small wire. I used ~11mm socket (deep socket) to remove the large wire. Everything was metric. It was not an overly difficult repair. Wiggling the starter in and out of position was probably the hardest part. Remember to disconnect your battery before starting.
