0
What the error code p1130 mean for Toyota sienna 2000 and where is air fuel sensor located thanks?
There are 2 sensors. One located within the engine compartment mounted on the exhaust pipes next to the engine block. The other is located next to the catalytic converter. As far as the code is concerned, consider taking out the sensor, clean it and reinstall it. Erase the code. Run engine for a couple of days. If the code comes back you should then replace the old sensor with a new one.
What else can I help you with?
Engine light code p1130 1999 Toyota Sienna?
i have check engine light on code po171 system to lean i changed o2 sensor check engine light came back soon after, i heard that it could be fuel air ratio sensor,where is it located on 6cyl Toyota sienna, do you have any input thanks tony
How do you replace a factory antenna on a 2002 Toyota Sienna?
"How do you replace a factory antenna on a 2002 Toyota Sienna?" I am talking about the whole assembly. Thanks
Car alarm reset button for Toyota Sienna?
I have a Toyota sienna 2003 van, LED of the car alarm keeps blinking even I deactivate it to open the doors . Please tell me how to reset it? thanks Peter
Can't get the rear door latch to open in our 2000 Toyota Sienna?
hi please show how do i replace the Toyota seinna 2000 front handle door thanks Andy
Where is a oil pressure sensor located on a Nissan Frontier?
where is the oil pressure sensor located on a 2005 frontier 4 liter v6 thanks
Where is the speed sensor located on the 2005 Nissan altima?
I HAVE A PO725 CODE IN MY 2005 ALTIMA, WHERE IS THE ENGINE SPEED SENSOR AT,THANKS 2.5
How long last a Toyota Sienna engine last?
A Toyota Sienna engine can last between 200,000 to 300,000 miles with proper maintenance, including regular oil changes and timely repairs. Many owners report their Sienna engines reaching these high mileages, thanks to Toyota's reputation for reliability. Factors such as driving habits, maintenance practices, and environmental conditions can also influence engine longevity. Regular check-ups and addressing issues promptly can help extend the life of the engine.
Where can you find the knock sensor in a 1989 Toyota Cressida?
The knock Sensor in a 1989-1992 Toyota cressida is located under the intake manifold, closer and under the cold start injecter. Behind the alternater. i had to use a small mirror to see it, or you can put your hand under and search for it. Also look at this tread forum: http://www.toyotanation.com/forum/showthread.php?t=213375 Thanks
Where is the oxygen sensor on 97 leSabre?
Hi , hope you can help me. Can you tell me where the oxygen sensor and the EGR valve are located on my 1997 Buick LaSabre. Thanks
I now have a code P 0161 The truck is a 02 Dakota with a 4.7 Whats the code mean and if a sensor wheres it located thanks?
P0161 is a Lambda heater sensor malfunction (oxygen sensor) located in the front section of the exhaust system.
Were is the Coolant Temperature Sensor located on the 1988 Mazda 323?
The sensor is threaded into the head to the left of the thermostat housing and has a single wire connector on it. Thanks Malcolm
Does my 1998 Toyota Camry 4cyl.4 door have a pulsed frequency map or maf signal or wideband o2 sensor Also does this car have more than 1 o2 sensor or map sensor before the catalytic converter thanks?
Toyota 1998 4cyl. have 2 oxygen sensors and MAF sensor. For more info and wiring diagram visit http://www.hhogear.com
