answersLogoWhite

0

Recommended Fluid is Dexron II or Dexron III ATF as per page 10-23 in the "OWNER'S MANUAL".....

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you add transmission fluid to a 2013 subaru outback with a continuously variable transmission?

There is no gauge according to your owners manual. As such you would not know if it needed fluid so adding fluid would not be wise. Service is done by the Subaru dealer. Good to have one less maintenance item, isn't it?


Why is your 99 Subaru Legacy Outback AT Oil Temp Light flashing and shift hard?

Your At Oil light reports the condition of the transmission and its fluid. Some times this problem can be fixed by changing your transmission fluid and assuring that the levels are correct when you refill the transmission. We hope that this simple routine maintenance we fix the problem, but it might not. You could have a "burnt" or worn out Central differential in your transmission. This is the part that pumps your fluid throughout the transmission and thereby creates the pressure needed for your transmission to shift gears.


Where is the O2 relay located in a 2007 Subaru Outback?

To the best of my knowledge there is no O2 relay. Why would you think one is needed?


How many quarts of oil are needed for an oil change on a 1991 Subaru Legacy L?

4.2 w/ filter


Can you replace a 5spd transmission of a Subaru Forester with a 6spd Subaru impreza wrx?

You can not replace transmissions due to the amount of room needed in the car


Where is the blower motor relay located in a 2002 Subaru Outback?

In a 2002 Subaru Outback, the blower motor relay is typically located in the engine compartment fuse box. To access it, open the hood and find the fuse box near the driver's side. The relay is usually labeled on the cover, making it easier to identify. If needed, you can refer to the owner's manual for more specific details and diagrams.


How do you remove the coin tray in a 2002 Subaru Outback?

To remove the coin tray in a 2002 Subaru Outback, start by gently pulling it out to its fullest extension. Once fully extended, look for a small tab or clip on either side of the tray that holds it in place. Press or lift the tab while simultaneously pulling the tray outwards to release it. If needed, you can also check for any screws securing it, but it typically just clips in.


Is it possible put Subaru EA81 engine in 1979 Brat?

Yes it will fit but you need a Donor car for needed parts. The transmission will be needed because of the location of the starter. The Head pipe will be needed as well. Like I said, you need a donor car


What is the blue book value for a 2006 Subaru Outback?

Of course you know that you have not given nearly enough information to get a reasonable answer. Like asking how much a blue car is worth. ;-) My favorite place to check is kbb.com. It will guide you through the information needed.


How many hours of labor to replace timing belt on 01 subaru outback?

Replacing the timing belt on a 2001 Subaru Outback typically takes around 4 to 6 hours of labor, depending on the mechanic's experience and any additional repairs that may be needed during the process. It's important to note that this task often involves removing other components, which can affect the overall time. Always check with a qualified mechanic for a more accurate estimate based on your specific vehicle condition.


How to reset driving distance to empty of 2102 Subaru legacy?

To reset the driving distance to empty on a 2012 Subaru Legacy, first ensure the vehicle is in the "On" or "Run" position without starting the engine. Then, press and hold the trip meter reset button on the dashboard until the display resets. This action typically recalibrates the fuel gauge, including the distance to empty reading. If needed, you can also try refueling the vehicle to help the system update.


How do you replace the headlights on a 2005 Subaru Outback?

The User's Manual describes all steps needed to replace the headlights including the bulb numbers you need. Most people should be able to do it in less than 5 minutes and the only tool you need is the screw driver located by your spare tire.