answersLogoWhite

0

Try adding dry gas into the tank at every fill up, its possable that water is some how getting into your gas tank. You may also consider changing the gas you use and the gas station you fill up at.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

What makes my 98 buick lesabre dies while driving?

One of the main causes for a 1998 Buick LeSabre to die while driving is a problem with the computer. The computer might tell the fuel pump to shut off and stop sending fuel to the motor.


How do you adjust the idle speed on a 1990 Buick LeSabre FWD?

The computer does it for you through the IAC valve Idle air control its under throttle body intake hose.


What is wrong when a 1996 buick lesabre is not idling?

throttle positioning sensor


Where is the throttle body on a 2001 Buick lesabre?

On top of the engine, drivers side.


Where is the computer in a 1994 Buick lesabre?

On my 1994 Lesabre it is under the dash about center at edge of carpeting


Why does my 1994 3.8 lesabre engine runs rough at a light throttle and on cruise control?

check for vacuum leak.


Where is the mass air flow sensor located on a 1993 Buick LeSabre?

directly on top of the throttle body intake


What causes the engine to idle so fast on a 1995 Buick Lesabre 3.8?

throttle position sensor believe it or not!


Where is a idle sensor on a 1993 Buick Lesabre located?

The Idle Air control valve is located on the side of the throttle plate.


What could cause a 1994 Buick LeSabre to stall when attempting to accelerate over 50mph?

the tps is bad-throttle positioning sensor


How do you adjust the idle on your '94 buick LeSabre?

May be computer controlled and not adjustable


Where is coolant temp sensor for 93 Buick lesabre?

The Coolant Temperature Sensor on a 1993 & 1994 Buick LeSabre is located on driver's side of the car under the throttle body, It is screwed into the lower intake manifold. You cannot see it without first removing the throttle body since it is hidden under it. An electronic plug is clipped to the the end of the CTS.