The 2002 Mitsubishi Gallant radio has two fuses. There will be an in-line fuse behind the radio. There will be a radio fuse in the fuse box.
I believe it's behind the radio/console area
codigo de radio galant 2001 gra
Pull the yellow box up to loosen both fuses at once, after this the fuses are only held in by the tabs inside of the yellow 'fuse holder'
Where is the radio antenna located on a 2003 Mitsubishi eclipse
It is most likely located in the center console behind and below the radio. It can be accessed by removing the kick panels from both the driver and passenger sides of the center console.
Leave the key in the "on" position for about an hour.
You can find it on the back of the radio (you have to take it out of the dashboard) or go to any Mitsubishi dealer and they will tell you.
where are the fuses to the radio located at
To find the anti theft code for a 2000 Mitsubishi Galant, you must visit a dealer. You must have the radio serial number, the radio part number, and the VIN.
there is not a "generic" radio code,if you have your owners manual it will be in there,if not WELL you have to take out radio get serial # and possibly model # off radio and go to Mitsubishi and begg and pleed with them to research it for you.you can try Google search and might luck out.
The radio code for a 2000 Mitsubishi Galant is typically a unique four-digit number that is specific to each vehicle. If you need the code, you can usually find it in the owner's manual, on a card that came with the vehicle, or by contacting a Mitsubishi dealer with your vehicle identification number (VIN). Additionally, some online resources may help retrieve the code if you provide the necessary information.
To remove the radio in a 2007 Mitsubishi Galant, start by disconnecting the negative battery terminal to ensure safety. Next, use a flathead screwdriver or a trim removal tool to carefully pry off the trim panel surrounding the radio. Once the trim is removed, unscrew the bolts holding the radio in place, disconnect the wiring harness and antenna cable, and then gently pull the radio out. After that, you can install the new radio by reversing the steps.