answersLogoWhite

0

Your model has two oxygen sensors. The first, called the precatalytic converter oxygen sensor, or precat, is located at the end of the exhaust manifold. If you look down between the engine and the firewall, you'll see your exhaust. The small plug with a wire leading back to the engine is your precat sensor. The second oxygen sensor is the postcat and is used to check on the catalytic converter. It's mounted in the back of the converter itself and can only be seen from under the car. These locations are true for all third generation Integras with the exception of the 94-99 GSR. In this case, the precat is located in the front of the converter instead of at the end of the manifold.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the oxygen sensor located on a 1995 Acura Integra?

on the header


Where is the main relay on a 1996 Acura Integra?

where is locate the main relay on 1996 acura integra


Where Oxygen sensor on Acura Integra 1996?

There is 2 o2 sensors on 96 integra. 1 is after the headder and the 2nd one is at the end of the cat


Where is the oxygen sensor located on a 1991 acura integra?

It is on the exhaust manifold. If you look down at your exhaust manifold there should be one plug sticking out of it. That's the O2 sensor.


Where is the Oxygen Sensor Signal Wire located in a 1996 Acura Integra?

The oxygen sensor is connected by a wiring harness. The wiring harness contains the signal wire. The signal wire goes to the system computer.


Ecu error code 17 in 1988 Acura Integra?

The ecu code 17 in the 1988 acura integra is for the VSS (vehicle speed sensor). Hope this helps you.


Where is the crank position sensor on a 1993 Acura Integra ls?

There isn't one.


How do you change and what tool you use to change out the temp sensor on a 95 Acura integra?

To change the temperature sensor on a 1995 Acura Integra, first, locate the sensor on the engine, typically near the thermostat housing. Disconnect the negative battery terminal, then unplug the electrical connector from the sensor. Use a socket or wrench to remove the old sensor and install the new one, ensuring it is properly seated. Reconnect the electrical connector and the battery terminal, and check for leaks before starting the engine.


Where Is Crank sensor located on 1995 Acura Integra?

inside the distributor inside the distributor


Your speedometer on your Acura Integra stop working is their a fuse?

Answermy 99 acura integra has a fuse for gauge cluster, alternator, speed sensor vss o2 sensor is fuse 15 under the dashboard that fuse control all of them check that out


Does a 91 Acura Integra have a b16 engine?

91 acura integra has a b18 91 acura integra has a b18


Where is the themostat on the 1996 Acura Integra locate?

If yoor 1996 Integra has the1.8L engine, the thermostat is located at the back of the motor at the end of the bottom radiator hose.