To change the temperature sensor on a 1995 Acura Integra, first, locate the sensor on the engine, typically near the thermostat housing. Disconnect the negative battery terminal, then unplug the electrical connector from the sensor. Use a socket or wrench to remove the old sensor and install the new one, ensuring it is properly seated. Reconnect the electrical connector and the battery terminal, and check for leaks before starting the engine.
No
Blown fuse, bad fan motor, defective thermal switch or a bad fan relay. Or check the coolant temp sensor.
if you look just under the distributor you will see where from right to left you have a radiator hose, heater hose, then two sensors, the sensor furthest to the left is your coolant sensor, I was troubleshooting mine earlier and started the car with it disconnected i got check engine light with p0118 (coolant temp sensor) so there ya go
The temperature sensor is malfunctioning
change the water temp sensor
There are a few possibilities for the problem. The most likely are the main relay and the engine temp sensor. The main relay is a problem very common to older Honda/Acura models, and the temp sensor is a common cause is general.
There's no need to change it if it's not broken.
There isn't an overdrive sensor. There are pressure switches, a temp sensor, solenoids, and speed sensors.There isn't an overdrive sensor. There are pressure switches, a temp sensor, solenoids, and speed sensors.
almost 100 % the termostat does not open it is stuck/considering you check the liquid level and is normal/.There is slite posibility to be the water pump. The thermostats are cheap and verry easy to change, so i would try that first. Also check the coolant temp sensor, usually located in front of the rad in the front of the engine(1 or 2 wires running from it)
The sunbeam sensor works with the inside and outside temp sensors to help adjust the ac for sunny days. This will keep a more comfortable environment to ride in.
There should be a module under the dash on the passenger side towards the center of the dash that is mounted to a bracket. When the fan is running unplug it, should stop the fan.
code 15 coolant temp sensor low temp indicated change cts sensor or test with multi meter