0
Where do the wires go when installing the alternator on a 1982 280ZX 2 2 non-turbo?
When installing the alternator on a 1982 280ZX 2+2 non-turbo, the main wire from the alternator connects to the positive terminal of the battery, typically via a junction point on the starter or battery cable. The smaller wire, often a plug connector, connects to the alternator's field terminal. Additionally, ensure the ground is securely attached to the engine block or alternator housing. Always refer to a repair manual for detailed wiring diagrams specific to your vehicle.
What else can I help you with?
How do you get the Alternator out of a 79 280ZX?
remove the belt, unhook all of the wires, unbolt the bolts, try a pry bar to unwedge it if wedged then it should just come off
How do you remove the wires from the alternator on a 1997 Toyota tercel?
how do you take the wires from the alternator on a 1997 Toyota Tercel
How many wires go to an alternator?
Number of Wires to an AlternatorThat depends on:the alternator,the wiring system in the vehicle
Remove and replace alternator on Chrysler cirrus?
disconnect the battery. Remove the alternator belt then disconnect the wires. Unbolt the alternator and remove. Bolt the new alternator in then connect the wires, belt, and battery.
Where do the wires go on a Vauxhall alternator?
from the back of the alternator to the dash to the battery
Wiring diagrams for 1982 Datsun?
alternator wires
Where do the alternator wires go on a 1986 Nissan pickup?
need diagram for 1986 Nissan truck alternator
How do you replace alternator on 97 cutlass 3.1?
Disconnect the battery negative. Loosen the belt and remove it from the alternator pulley. Disconnect all wires from the alternator. Unbolt the alternator from the bracket. Remove the alternator.
What are the wires for on alternator?
There should be a heavy wire called the Alternator output wire, It carries power from the alternator to power your accessories and to maintain your battery. The smaller wires usually in a plug are either the alternator's voltage sense, Stator/ACurrent/Tachometer output, regulator/indicator light. or if its an Externaly regulated alternator they will be alternator Field, Stator/ACurrent/Tachometer. hope this helps
Where does the wires go when installing alternator on 1980 Datsun 280z?
Red Positive goes to Battery Positive and the small lead goes to the ignition light bulb in the dash which Will be negative until starts charging which will be positive and the light will go out
Remove and replace alternator on a 71 cucda 440?
unbolt it, take the belt off, take the wires off the alternator and replace with new alternator.
How do you remove the alternator in a 300d?
Disconnect battery. Disconnect wires from alternator. Loosen bolts and remove belt. Remove bolts holing alternator in place.
