To refill the brake fluid for a 1992 Acura, you need to remove the cap on the brake fluid reservoir. Add fluid until the dipstick measures full, or the line on the reservoir that says 'full' is touched by the brake fluid.
how do you add transmission fluid on 98 acura cl 3.0
read the manual
On my '94, I went through dipstick. Make sure you get the HONDA/ACURA fluid from the dealer.
in the engine
To change differential fluid on a 1997 CR-V the vehicle needs to be lifted up to reach the rear differential. Find the drain plug located on the underside of the unit. Pull the plug and drain the fluid, when done place the plug back add fluid into the fill hole which is located topside of the differential.
To add front differential fluid to a Suzuki King Quad 300, locate the front differential housing, which is typically situated near the front axle. Remove the fill plug, usually found on the top or side of the differential case. Use a funnel to pour the appropriate type of differential fluid into the housing until it reaches the fill level, then securely replace the fill plug. Always refer to the owner's manual for specific fluid specifications and maintenance recommendations.
If it is an automatic transmission, you add transmission fluid with a long funnel through the dipstick opening.
The rear differential fluid goes directly into the rear differential. There is normally an inset plug that has a square drive on it that accepts a 3/8" ratchet or ratchet extension. Remove this plug. If fluid comes out, you do not need to add any. If no fluid comes out, add enough of the fluid recommended by your vehicle manufacturer (normally 80/90 gear lube, but not always) where you took out the plug, until it starts to seep out the plug hole. Replace the plug and you're finished.
Look at the rear differential housing - you will see two plugs in the housing an upper and a lower. Loosen the upper plug - if fluid runs out of it you have sufficient fluid - if not - add fluid until it just starts running out - then replace plug.
To check or change the differential fluid in a 1989 Club Car golf car you will need to remove the oil cover. Unscrew the bolts and brass fitting.
To check the front differential fluid level on a 2005 Ford Explorer, first, ensure the vehicle is on a level surface and safely supported. Locate the front differential, which is typically found near the front axle. Remove the fill plug, usually located on the side of the differential housing, and check if the fluid is level with the bottom of the plug hole; if it drips out, the level is sufficient. If not, you will need to add the appropriate differential fluid until it reaches that level.