how to check the fluid on a manual transmission for a 1989 ford probe gt
What ar the symptoms? Check the fluid,is it full? What color is the fluid.
To change the gear oil in a 1989 Mazda 323 with an automatic transmission, first ensure the vehicle is on a level surface and the engine is warm. Locate the transmission fluid dipstick, remove it, and check the fluid level. Then, drain the old fluid by removing the drain plug, if applicable, and replace it with new fluid through the dipstick tube, using the manufacturer-recommended type. Finally, check the fluid level again, ensuring it's within the recommended range, and replace the dipstick securely.
On a 21 year old car I would not do a flush. You may stir up trouble, so just do a fluid change.
There is no external transmission reservoir. Transmission fluid is stored in the transmission. Fluid is added at the same point at which you check the fluid level.
There is a power steering reservoir under the hood of the car. Remove its cap, and the dipstick is attached, this is where a person can check the fluid level.
You check and fill under the car on the side of the tranny a plug.
a 1989 trans am gta has a limited slip differential
You add automatic transmission fluid to a 1989 V6 3.0 Toyota pickup truck through the filler tube in the engine compartment. This is also used to check the fluid level.
It uses the engine oil aswell. just check your engine oil that's it.
Might want to check for leaking radiator hoses and / or lack of fluid to and from the radiator 1st. Also, check and or change the thermostat before going to the more expensive stuff like bad water pump, etc!
try using steel seal. you put it in your coolant and it seal the leak if theres exhaust gases in your radiator fluid or if your getting radiator fluid into your piston area. check out steel seal and i swear it will work for you its great!