On all Toyotas (as I was told by a service parts worker) on the passanger side door the code for the key is on the lock cylinder itself. You must remove your door panel (make sure to check for ALL of the screws that hold it together or you'll mess it up and break it) then there should be a hole beneath where your lock is located. You must remove any thing that is covering the lock and then it should be engraved on the actual cylinder.
it is stamped on the passanger door lock
Toyota ,, 2010 Toyota. Corolla
have to go to dealer
Yes. It has a transponder key that if you use the wrong key it will not send the correct code to the ECM. Hence no start.
LR 2032
Yes passive to detect key
You will find the key code on the drivers door lock cylinder. Must remove the whole lock cylinder to read the code. You will find the key code on the drivers door lock cylinder. Must remove the whole lock cylinder to read the code. Go to the dealership and give them the VIN number. They will be able to make a new key right there based on the VIN.
door panel
==Answer 1 == Sounds like the ignition switch is defective.
To reset the alarm on a 2005 Toyota Corolla, first ensure the vehicle is unlocked using the key or remote. Then, insert the key into the ignition and turn it to the "On" position without starting the engine. After a few seconds, turn the key back to the "Off" position and remove it. This should reset the alarm system. If the alarm persists, consult the owner's manual for further instructions or check the battery of the key fob.
You can get a new key for your 1999 Toyota Corolla by visiting a Toyota dealership. Many car manufacturers make their keys in such a way that they're impossible to copy at any place other than a dealership as an anti theft precaution.
To disarm a 1998 Toyota Corolla alarm, first, use the key fob to unlock the doors, which should deactivate the alarm. If you don't have the key fob, insert the key into the driver's door lock and turn it to the unlock position. Alternatively, you can disconnect the car battery for a few minutes to reset the alarm system. If the alarm persists, consult the owner's manual or a professional for further assistance.