0
What else can I help you with?
Where is the location of obd2 for 1998 Toyota Camry?
It's behind the plastic cover shield, behind the steering wheel.
Is The 1993 Toyota Camry An OBD1 or OBD2?
OBD1
How do you reset the check engine light in a 2002 Toyota Camry?
It is reset with a OBD2 scan tool, after the repair of the system.
Where does the obd2 scan go on a 2001 Toyota Camry?
The port should be under the steering wheel at very end of the plastic shield.
Can you use a obd2 reader on a 1993 Toyota Camry?
It depends on reader. If you reader can supports OBD I and has appropriate adapter then you are good to go.
Why don't have communication with the scan tool?
I have toyota camry 2003se. There is no communication obd2. Scan doesn't connect. Tested all wires, from obd2 connector to ecu, replaced ecu to test, ecu ok.
Can you add a Crankshaft posistion sensor from a 1998 Geo metro on to a 1993?
no they didnt have them till 1996 with the obd2
How do you reset the check engine light on a 2002 Toyota Camry?
you need a obd2 compatible scanner to reset the light.you can not do it any other way sorry hth Dave
Where is the obd2 port in a 1998 tacoma?
The OBDII on a Toyota Tacoma 1998 is located on the driver side under the console right above the gas pedal... I should know I own a Tacoma 1998.
What type of obd connector is in 1998 Nissan sentra?
OBD2
How do you test a 1999 daewoo nubira oxygen sensor when the car goes for the smog test it says obd2 fail?
obd2 means on board diagnostics failed not o2 sensor, 1st have to figure out why obd2 failed.
Where is the sensor for an OBD2 Code P1155 on a Toyota Solara?
The OBD2 code P1155 on a Toyota Solara typically refers to an issue with the air-fuel ratio sensor, which is located upstream of the catalytic converter, integrated into the exhaust manifold or near the engine. Specifically, it is often positioned before the first catalytic converter in the exhaust system. This sensor monitors the air-fuel mixture and provides data to the engine control unit for optimal performance. If experiencing this code, it's advisable to check the sensor and its wiring for faults.
