answersLogoWhite

0

I have Toyota camry 2003se. There is no communication obd2. Scan doesn't connect. Tested all wires, from obd2 connector to ecu, replaced ecu to test, ecu ok.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is causing a 2008 Sebring 2.4 communication error on scan tool?

Check for a blown fuse.


How do you reset the computer on a 1996 Ford Taurus?

OBD2 scan tool. i dont know


How do you check the engine codes on a 2000 Camry?

need factory scan tool or aftermarket scan tool need factory scan tool or aftermarket scan tool


Is the electronic control moduler bad if you use a scan tool and error comes up on the screen?

Not sure what error you mean, a communication error can be caused by a module, any intermediate wiring or the scan tool itself.


How do you reset the computer on a 2004 dodge intrepid?

With a scan tool, or unhook the battery for 5 minutes.With a scan tool or by unhooking the battery.With a scan tool, or unhook the battery for 5 minutes.With a scan tool or by unhooking the battery.


How do you get fault codes from a 2002 Jeep Liberty?

With a scan tool.With a scan tool.


How do you reset mil lamp in Jeep Compass?

With a scan tool.With a scan tool.


What does an error code no bus mean on a 2007 jeep compass?

The "bus" is the communication system for the computers. No bus means the system is not working. You need a scan tool, wiring diagrams, and a volt meter to diagnose.The "bus" is the communication system for the computers. No bus means the system is not working. You need a scan tool, wiring diagrams, and a volt meter to diagnose.


How do you check error codes on 1997 dodge caravan?

With a scan tool.With a scan tool.


How can you retrieve the airbag code for a 1999 jeep Cherokee?

With a scan tool.With a scan tool.


How do you reset Maint REQD light on a 1997 Dodge Dakota?

A scan tool is required.A scan tool is required.


How do you set injection timing on 99 dakota 3.9 motor?

A scan tool is required. The distributor is "zeroed" with the aid of the scan tool. This can not be done with a timing light.A scan tool is required. The distributor is "zeroed" with the aid of the scan tool. This can not be done with a timing light.