To add coolant to a 2000 Toyota Echo, open the hood and locate the coolant reservoir, which is typically a translucent plastic tank near the radiator. Ensure the engine is cool, then remove the cap from the reservoir and add the appropriate coolant mixture, usually a 50/50 mix of antifreeze and water. Always check the fill level markings on the side of the reservoir to avoid overfilling, and secure the cap tightly after adding the coolant.
I have the same thing on 2000 echo, I was told to put a long screwdriver on the alternator then put my ear to the screwdriver to hear if the squeal is coming from the bearing after verifying the belt wasn't the problem.
the same way u take them off
4 L
It is not suggested to put water in a Toyota Rav 4. The engine cooling system can get too hot and coolant is preferred. To pour coolant find the coolant reservoir and pour fluid until the max line is filled.
Fill it till all the cooling veins are covered with antifreeze and distilled water depending on you environment.
In the radiator
Pull the old one out and put a new one in its place. You may need a tool that is usually located in the fuse panel to remove the old fuse.
Never put just straight water in your motor. You want to top off your radiator first then top off your coolant in the reservoir. Water will rust your motor from the inside out.
Look at the radiator, it should be in the front. It has a cap on it, take it off and you can put coolant in side.
if you have the correct tools and professional help it should work.
The Honda 450 foreman 98-04 is air and oil cooled and does not require antifreeze or coolant.
because your coolant level is too low. put some antifreeze in it......