The airbag fuse is an integral part of the airbag control module and is not a replaceable part in itself. The airbag control module must be replaced.
The Mazda Miata air conditioning drain to can be found on the bottom of the air conditioner compressor. The drain to runs to the bottom of the oil pan.
mazda miata air bag code 21
A 1996 Mazda Miata uses R-134a as its refrigerant. This was a common refrigerant choice for many vehicles produced in the 1990s, as it replaced the older R-12 refrigerant due to environmental regulations. If you're servicing the air conditioning system, it's important to ensure that the correct type of refrigerant is used to avoid damage.
It should be in the air intake. It look like a light bulb filement most of the time. Look on the air intake box. Also look in the tube coming from the cowl.
Is it feasible and approximately how much will it cost to replace the air conditioner in my '91 Miata with a unit that does not use freon?
It doesn't have one. It uses a flapper type air flow meter which doesn't require an intake air temp measurement.
Look on the inside drivers door. On the door latch area there is a sticker that will give the air pressure for cold and hot air pressures.
There is a problem with the air bag system. Until it is fixed the light will remain on. Take it to a garage for repair.
The Mass Air Flow (MAF) sensor on a Mazda Miata is on the right side of the engine, when looking directly at the engine. It's a black, tube about 4" long, and connects right into the large, plastic black air box.
On a 1990 Mazda Miata, the relay for the air compressor, which is part of the air conditioning system, is typically located in the engine bay. Specifically, it can be found in the fuse box, which is situated near the driver's side of the engine compartment. You may need to refer to the owner's manual for the exact position within the fuse box, as relay layouts can vary.
The cabin air filter on a 2006 Mazda Miata MX-5 is located behind the glove compartment. To access it, you need to open the glove compartment, remove its contents, and then disconnect the stop arm to allow the compartment to swing down fully. Once lowered, you can find the filter cover, which can be removed to replace the cabin air filter.