0
What else can I help you with?
What is the gap for a 1986 Toyota Cressida?
Toyota spark plugs from dealer pre gaped
Where is the fuel pump for 1986 Toyota Cressida?
inside the gas tank
Where is the voltage regulator in a 1986 Toyota Cressida?
probly buitl in to the altinator drive safe
Where is the oxygen sensor located in a 1986 Toyota Cressida?
below exhaust manifold... left hand side... were the manifold joins into 1 pipe becoming the exhaust
How do you disable the theft deterrent system on a 1985 Toyota Cressida?
the 1985 cressida is like the 1986, the way to disable the system is with the key on either doors,
What is the spark plug gap 1986 Toyota Cressida?
I think it's "40". Any other suggestions????
Where is the carburetor located in a 1986 cressida?
Top of engine under air cleaner
Where is the expansion valve located on a 1986 toyota pickup?
In a 1986 Toyota Pickup, the expansion valve is typically located in the engine compartment, near the firewall. It is situated between the evaporator and the condenser, usually mounted on the evaporator case or near the AC compressor. Accessing it may require removing some components for better visibility and clearance.
Where is the pcv valve on a 1986 Toyota land cruiser fj60?
The PVC valve is located on the engine side cover near the firewall on the passanger side of the engine. Coyote John
When was Cressida - moon - created?
Cressida - moon - was created on 1986-01-09.
How do you remove 1986 Toyota Cressida alternator?
To remove the alternator from a 1986 Toyota Cressida, first, disconnect the negative battery terminal to prevent electrical shock. Then, remove the drive belt by loosening the tensioner and sliding the belt off the alternator pulley. Next, disconnect the electrical connections from the alternator and remove the mounting bolts securing it in place. Finally, pull the alternator out of the engine bay.
Where is the idle air control valve located on a 1986 Toyota MR2?
The idle air control valve (IACV) on a 1986 Toyota MR2 is typically located on the throttle body assembly. It's mounted on the side of the throttle body, which is situated between the air intake and the intake manifold. To access it, you may need to remove the air intake duct and possibly some surrounding components for better visibility and access.
