To remove the alternator from a 1986 Toyota Cressida, first, disconnect the negative battery terminal to prevent electrical shock. Then, remove the drive belt by loosening the tensioner and sliding the belt off the alternator pulley. Next, disconnect the electrical connections from the alternator and remove the mounting bolts securing it in place. Finally, pull the alternator out of the engine bay.
there are about 12 10mm bolts that hold the oil pan in place. remove them and the pan will drop right down.
Toyota spark plugs from dealer pre gaped
inside the gas tank
probly buitl in to the altinator drive safe
the 1985 cressida is like the 1986, the way to disable the system is with the key on either doors,
To change the heater core in a 1986 Toyota Cressida, first, disconnect the negative battery cable and drain the coolant from the radiator. Remove the dashboard, which involves taking out screws and clips to access the heater core housing. Disconnect the hoses from the heater core and remove the core from the housing. Finally, install the new heater core, reassemble the dashboard, and refill the cooling system with coolant.
I think it's "40". Any other suggestions????
To change the alternator in your 1986 Chevrolet Celebrity: 1, Remove the battery ground cable. 2. Unplug remove the wiring from the alternator. 3. Loosen the bolts that hold the alternator in place. Remove the drive belt. 4. Remove the bolts and the alternator will pull out. Reverse the process to reinstall the new alternator.
Replace Alternator
There are two bolts on the bottom of the alternator that you can't see but you can feel them, these are the pivot bolts, remove them. Then remove the adjustment bolt on top of the alternator. Remove wiring from back of alternator. Reverse instructions for install.
In side the Alternator, under a small service cover.
Cressida - moon - was created on 1986-01-09.