In a 1996 Subaru Outback, the backup light switch is typically located on the transmission. It is often mounted on the side of the transmission case, near the gear shifter linkage. To access it, you may need to lift the vehicle and remove any necessary undercarriage covers. Ensure to disconnect the battery before attempting any repairs or replacements to avoid electrical issues.
yes
how to replace high/low beam, turn signal lever on 1996 subaru outback wagon
To shut off the flashers on your 1996 Subaru Outback, locate the hazard light switch, which is usually found on the dashboard near the center console. Press the switch again to turn off the flashers. If they do not turn off, check the vehicle's manual for troubleshooting steps or ensure that the switch is not stuck.
Will fit Legacy/Outback Model Year 1995 to 1999.
There is no such thing as a 1995 subaru outback, the outback package was not offered on a subaru legacy until 1996, you either have a 1996 subaru outback, or you have a 1995 subaru Legacy L or LSI wagon. Both will be covered in most guide books you can pick up at your local autoparts store.
Top front of engine, beside Oil Pump, right above Oil Filter.
Two.
A 1996 Subaru Legacy Outback requires: For automatictransmission: DEXRON III For manual transmission: GL5 75W90 gear oil
Should fit second generation Legacy/Outback model year 1995 to 1999.....
Check out http://www.fueleconomy.gov/feg/sbs.htm
Take them out then put the new ones in
Directly below the alternator on the block.