It is located on the transmission box nearby the engine
if its like a "86" you just pull back on the light switch i
To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.
It's right in the transmission, rear top portion before the propeller shaft..
The "trip odometer" on the dashboard doubles as a dimmer. So, the solution to no lights inside the Toyota Sienna is to turn the trip odometer up to turn the lights back on.
On the back of the engine block.
I have yet to do this on my 2005 Camry, but according to the Toyota Tech you must turn the key switch over (do not crank car) the check engine light will appear, now hold down the button on the odometer and at the same time turn the switch off than back on.
I was told by my parts guy that the back up light switch is the same as the reverse light switch.
the back up light switch is located in the gear shifter console
switch is on the transmission
To wire a light switch to a light, you will need to connect the switch to the power source and the light fixture. Turn off the power, remove the cover plate, and disconnect the existing switch. Connect the wires from the switch to the corresponding wires in the wall and the light fixture. Secure the connections with wire nuts and screw the switch back into place. Turn the power back on and test the switch to ensure it is working properly.
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
in the back of the rear engine