0
Bank 2 indicates the bank containing cylinder #2. Bank one contains cylinder #1. Passenger side cylinder #'s are 2,4,6. Driver's side's are 1,3,5. Make a diagram for yourself, it helps a lot for not forgetting.
Ok. Now that you know where bank 2 is. The GV v6 has 4 O2 sensors, 2 on each pipe that comes directly out of each manifold on either side of engine. On each side, one sensor is above or 'upstream' of the little pre catalytic converter, one is below or 'downstream'. The upstream sensor is #1, the downstream sensor is #2.
Therefore Bank 2 sensor 1 is the upstream or top sensor on the passenger side bank of cylinders.
This concerns the O2 sensors, which I assume is what you are referring to.
What else can I help you with?
Where is the thermostat on a 2000 suzuki grand vitara?
replace thermostat suzuki gran vitara 2000
Where is diagnostic port suzuki grand vitara 2000?
where is the diagnostic port for 2000 suzuki gr vitara
Does the suzuki grand vitara have a diagnostic port?
Looking for the 2000 grand vitara diagnostic port
Where is the air intake temperature sensor located on a 2000 suzuki grand vitara 2.5 liter?
Connected to the air intake.
Where are the spark plugs located on a 2000 suzuki grand vitara?
Screwed into the heads.
How do you repair crank sensor on Renault auto scenic?
2000 suzuki vitara 2.0 crankshaft sensor
Where can you find a giude on how to replace the timing chain 2000 Chevy Tracker with 2.0?
either Suzuki Vitara or Grand Vitara I have a 2.5 V-6 Tracker and mine is listed as a Suzuki grand Vitara Yours being a 2.0 4 cyln I'm not sure but it is made by Suzuki
Where is the pcv valve located in 2000 suzuki grand vitara?
need to know the size of the engine
Where is the oil pressure bolt on a Suzuki grand Vitara 2000?
Near the oil filter, just above in.
Serpentine belt diagram for 2000 suzuki vitara?
http://serpentinebeltdiagrams.com/2000-2006-suzuki-vitara-belt-diagram/
How do you change the crankshaft sensor on a 2000 Suzuki Vitara?
you have to separate the engine and tranny to have access!! very labor intensive
Where is the crankshaft position sensor on a 2000 suzuki grand vitara?
On a 2000 Suzuki Grand Vitara, the crankshaft position sensor is typically located near the crankshaft, often found on the engine block or transmission bell housing. Specifically, it is usually positioned on the lower part of the engine, near the oil pan or the front of the engine, depending on the engine configuration. To access it, you may need to remove some components or covers. Always refer to the vehicle's service manual for exact location and removal instructions.
