you have to separate the engine and tranny to have access!! very labor intensive
2000 suzuki vitara 2.0 crankshaft sensor
On a 2000 Suzuki Grand Vitara, the crankshaft position sensor is typically located near the crankshaft, often found on the engine block or transmission bell housing. Specifically, it is usually positioned on the lower part of the engine, near the oil pan or the front of the engine, depending on the engine configuration. To access it, you may need to remove some components or covers. Always refer to the vehicle's service manual for exact location and removal instructions.
The bank one sensor, on your Suzuki Grand Vitara XL7 4 x 4 is located on the front of the transmission. The sensor will have 3 wires coming from it.
Where can i find the right wheel abs sensor
Underneath the alternator
The crankshaft position sensor on a Suzuki Vitara V6 2.5 is typically located near the bottom of the engine block, close to the crankshaft pulley. It is often mounted on the engine's front or rear, depending on the specific model year. To access it, you may need to remove some components, such as the engine cover or other accessories, for better visibility and reach. Always refer to the vehicle's service manual for precise location and removal instructions.
I have a Grand Vitara 2.0td 2004. The ECT is under the alternator on the left side of the engine
were is crankshaft sensor located in 2001 Saturn l300
Connected to the air intake.
Its on top of the clutch bell housing using the flywheel as the trigger Its imposable to get at
i need to know. my1996 1600 geotracker engine carries a crank sensor, i am replacing it with a vitara engine but it does not carry a crank sensor. the vitara distributor only has two wires. how do i configure, cause the geo distributor has 7 wires
How do you change the crank sensor on a 2002Nissan Atima3.5?