On a 2007 Suzuki SX4, the blower resistor is typically located behind the glove compartment. To access it, you may need to remove the glove box and possibly some surrounding panels. The resistor is usually mounted to the HVAC housing and connected by wiring harnesses. Always consult the vehicle’s service manual for precise instructions and safety precautions.
Blower motor resistors are usually located close to the blower motor.
Blower resistor has failed. It is located behind the glove box.
On the passenger side underneath the dash, look for a connector with four wires. The blower motor resistor should have two small bolts holding it in place
Location of 2007 heater blower Transistor resistor
To replace the blower motor resistor on a 2007 Infiniti G35, first, disconnect the negative battery terminal to ensure safety. Next, remove the glove compartment to access the resistor, typically located near the blower motor under the dashboard. Unplug the electrical connector from the resistor, remove the screws securing it, and take out the old resistor. Install the new resistor by reversing the removal process, reconnect the electrical connector, and reassemble the glove compartment before reconnecting the battery.
It's in the bottom of the blower motor, on the side of it. You can look by taking the door down on the glove box or it may be below that. It is where you need to look though.
You will need to change the blower motor resistor by finding it near the air duct system. You will take the old resistor off and replace it the same way.
To replace the blower motor resistor on a 2007 Nissan Quest, first, disconnect the negative battery cable to ensure safety. Then, locate the blower motor resistor, which is typically found under the dashboard on the passenger side, near the blower motor. Remove the electrical connector and the screws securing the resistor in place, then replace it with the new unit and reassemble everything. Finally, reconnect the battery and test the blower motor to ensure it operates correctly.
Blower motor resistors are usually located close to the blower motor.
I was able to access the blower by removing the glove box. The blower is toward the top and to the firewall. It was a tight squeeze getting it out and back in.
Blower motor resistor defective
The blower motor resistor on my 2007 Chev. Colorado is located on the passenger's side, under the dash, behind the glove box. You don't need to remove the glove box, just lay on the floorboard and look up under the dash. There's a 4-wire harness plugged into the resistor assy (white plastic), in the bottom of the black heater blower shroud. Unplug the harness, remove two small screws, and pull down to remove the resistor assy.