answersLogoWhite

0

behind harmonic balancer,front of engine(passenger side of car is "front") balancer is large pulley down low - must use harmonic puller to remove- DO NOT use standard puller or you will destroy it (costs about $300.00 to replace)then also need to remove cam-belt cover

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the crank sensor located on a 1998 Mitsubishi 3000 gt?

there is no crank sensor on a Mitsubishi 3000 gt but there is a crank angle sensor that looks just like a distributor its in the back of the engine on top between valve covers


What if the crank sensor is bad on a 1993 Mitsubishi 3000 gt?

If the crank sensor on a 1993 Mitsubishi 3000GT is bad, the engine may experience difficulty starting, misfire, or may not run at all due to the engine control unit (ECU) not receiving accurate information about the crankshaft position. This can lead to poor engine performance, stalling, and increased fuel consumption. It's essential to diagnose the issue using a code reader and, if confirmed, replace the faulty sensor to restore proper engine function. Ignoring this issue can lead to further complications in the ignition and fuel systems.


Why wont a Mitsubishi 3000 gt crank if battery is good?

Starter is not working.


What would cause a Mitsubishi 3000 gt 1994 to intermittently start and run well and then occasionally turn over but not start for a few days and then start and run well again -- car has new battery?

It is the crank positioning sensor.


Wiring diagram for 1993 Mitsubishi 3000 gt?

http://www.3sx.com/faq/manuals/


What would cause a 1992 Mitsubishi 3000 GT to start and run then die crank and no fire afterward?

ECU Caps dead


Where is the speed sensor on a 1995 Mitsubishi 3000 gt located?

On top of the transmission, near the clutch slave cylinder.


What causes a 1993 Mitsubishi 3000 gt sl transmission failure?

Overheating?Low oil Level?Worn out?


What causes vibrations while coasting in 1st gear on a 1993 Mitsubishi 3000gt VR4?

Bad struts can cause vibrations while coasting in first gear on a 1993 Mitsubishi 3000 GT VR4. A bad tire can also cause this.


What does 3000 gt means?

3000gt is a Mitsubishi car.


Where is the inertia switch on a Mitsubishi 3000 GT?

in the trunk


How do you change an alternator ground wire on a 1994 Mitsubishi 3000 GT?

Refer to your service and user manual on how to change an alternator ground wire on a 1994 Mitsubishi 3000 GT.