0
The idle control valve on a 2004 Mitsubishi Galant ES is located on the throttle body, typically near the intake manifold. You may need to remove the air intake duct and possibly some wiring harnesses to access it. It is important to ensure the engine is cool and to disconnect the battery before attempting any work on the valve. Always consult the vehicle's service manual for specific instructions and diagrams.
What else can I help you with?
Where is the strainer valve located in Mitsubishi galat 2004 2005 2006?
The strainer valve on the Mitsubishi Galant 2004, 2005, 2006 models is located next to the engine manifold.
What is the emission control system warranty on 2004 Mitsubishi endeavor?
Try here: http://consumerguideauto.howstuffworks.com/2004-mitsubishi-galant-3.htm Should be the same.
How do you change the transmission mount on your 2004 Mitsubishi Galant?
yellow
How many oxygen sensors are on a 2004 mitsubishi galant?
4
Is the 2004 Mitsubishi Galant an interference engine?
No. It's not interference engine.
Where is the speed sensor for 2004 Mitsubishi Galant?
the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.
Can you use 15-40 oil in a 2004 Mitsubishi galant 6 cylinder?
Can you? Yes. Should you? NO! Use exactly what Mitsubishi recommends and that is not 15w40.
Do you need a mechanic to replace an egr valve on a 2004 Mitsubishi galant?
No you do not! th egr valve is located just under the throttle body. there are 2 10mm bolts holding it in, you just need to remove air intake to the throttle body! it is directly under it!
Why won't your 2004 Mitsubishi galant air conditioner blow air when it turned on?
Low refrigerant? Blown fuse?
How do you change tracktion control sensor for 2004 galant gts?
Change it
Where is your PCV valve located on your 2004 Mitsubishi lancer?
under the hood
Why is there a grinding noise in the back of my 2004 Mitsubishi Galant when im going slow?
The problem is probably the rear wheel bearings
