its located under the head on the drivers side you can buy the wire separate 25 bucks the head has to be removed
where is the nock sensor on my 95 toyota 4runner
it located under the transmission
The knock sensor on a 1999 Toyota 4Runner is located on the engine block, typically on the driver's side, near the intake manifold. It is usually positioned beneath the intake manifold, making it somewhat difficult to access. To reach it, you might need to remove the intake manifold or other components that obstruct access. The knock sensor is a small cylindrical component that detects engine vibrations to help adjust ignition timing.
engine bay
Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.
under the intake manifold
The manufacturer states throttle body and the intake manifold must be removed to access the knock sensor. The knock sensor is located on side of cylinder block.
The Knock sesor is located on the backside of the block right underneath intake manifold.
It should be in the side of the engine facing the firewall.
it's located under the intake manifold. the knock sensor is most likely ok' the porblem is the short wiring harness from sensor to main wire harness.
It is in the trough below the EGR and intake manifold alongside the water bypass tube. Be careful with it if you take it out as they appear to be expensive.
where is the knock sensor on a 95 Toyota t100 v6