0
What else can I help you with?
Where is the Knock Sensor located in a 2000 Subaru Outback Legacy?
It is located on the engine block drivers side.
Where is the knock sensor on a Subaru Forester 1999?
Where is the knock sensor located on a 1999 Subaru Forester?
Where is the knock sensor on a 1997 subaru legacy gt 2.2 liter?
It is threaded into the block, under the intake manifold.
How do you change a knock sensor on 1998 Subaru Outback?
that the knock sensor does
What is the torque specs for a knock sensor for a 1997 subaru legacy?
The torque specification for the knock sensor on a 1997 Subaru Legacy is typically around 8.5 ft-lbs (or 10 Nm). It's important to ensure that the sensor is tightened to the appropriate torque to avoid damage to the sensor or the engine block. Always refer to the vehicle's service manual for the most accurate and specific information.
What does the 2000 Subaru Forester knock sensor do?
If somebody knocks on the front door of the Subaru, the KNOCK sensor, sets off the KNOCK Alarm....LOL
Where is the knock sensor located on a 1996 Subaru Legacy 25?
It is underneath the intake manifold. If you look straight down from your throttle body, you will see a sensor with one wire coming out and a bolt going through the middle of it, that is the knock sensor.
How do you repair the wiring harness to the knock sensor for your 98 subaru legacy outback?
That depends entirely on what happened to it to make it need repairing.
Where is the knock sensor on a 2001 Subaru Forester?
The knock sensor is located near the idle air control solenoid valve on a 2001 Subaru Forester. The knock sensor is responsible for sensing vibrations caused by engine knock.
Where is the knock sensor on a 99 subaru legacy outback?
On a 1999 Subaru Legacy Outback, the knock sensor is typically located on the engine block, near the intake manifold. It is usually found on the driver's side, towards the back of the engine, and can be accessed by removing some components for better visibility. The sensor is a small, cylindrical device screwed into the engine, designed to detect engine vibrations and adjust timing accordingly.
How do you change a knock sensor on a 1997 Subaru Legacy?
It only involves one bolt and one wire, but its pretty difficult to access as it lives under the throttlebody.
Where is the knock sensor on a 98 subaru legacy outback?
Looking at the top of the motor remove the air intake and it is below the butterfly on the drivers side top end of the motor.
