answersLogoWhite

0

The OBD port for a 1992 Mazda B2200 truck is located under the dashboard, near the driver's side. Specifically, you can find it above the brake pedal, close to the steering column. It may be covered by a panel or plastic cover, so you might need to remove that to access the port.

User Avatar

AnswerBot

2w ago

What else can I help you with?

Related Questions

How do you use scan on Mazda 92 b2200?

The B2200 does not have "scan tool" capability. It does have a diagnositics port that can be used to throw out codes using the MIL light in the dash. There are about a dozen codes that at best tell you the obvious. There is lots of help on mazdatruckin.com that can help you diagnose your truck.


Where is the Diagnostic port on a 1992 Mazda Protege?

Near the battery. It will have "DIAGNOSTIC" on the cover.


How do you retrieve computer codes 1991 Mazda B2200 truck?

On the 86-93 mazda b series truck there is NOT a obd port to retrieve codes.The computers on these trucks are soley designed to run the fuel systems and emissions systems.There are NO codes to be retrieved and there is not a listing even made to do so on these year models.When doing diagnostics normally it is based on checking sensors and isolating based on that using a multimeter or advanced meters to check voltage,pressure for vacumm.Hope this clarifies things.Mazda did not go to the OBD until 1994 and newer models on the trucks.


Where is the low side service port on a 1992 Chevrolet 4x4 truck 305?

Its in the biggest line trace it from your a/c compressor.


1992 Ford F-250 Air Conditioner Low Pressure Port?

standing in front of truck, on left by blower housing


Where is the obd2 port located on 2002 Mazda tribute?

LOCATION OF OBD2 PORT?


Where do you add freon to Mazda 99 truck?

You would add R-134a to the low side port which can be found on the Receiver Drier. You can find a drawing spec of this on the website link below.


Does Mazda 6 2008 have aux port?

No.


Where to add freon to 1988 Mazda b2200?

It's now referred to as "refrigerant". It is also commonly referred to as Freon. Find the low pressure port,,,should be the smaller of the tow ports on the refrigerant lines. It will have a black, blue or green cap on it. That is where you introduce more refrigerant to the a/c system.


OBD scan port for 1992 Mazda 929?

The 1992 Mazda 929 is equipped with an OBD-I diagnostic system, which means it does not use the standardized OBD-II port found in newer vehicles. Instead, the diagnostic connector is typically located under the dashboard near the driver's side. To access the OBD-I codes, you may need a specific scan tool designed for Mazda vehicles of that era, or you can use a jumper wire to bridge specific terminals in the diagnostic connector to trigger the check engine light for code retrieval.


Where is the OBD II port on a 2002 Mazda Tribute?

The 2002 Mazda Tribute OBD 2 port is on rear edge of dash; right of hood release


Is the 1994 Mazda protege an obd-I?

Yes the 1994 Mazda Protege is a OBD 1 port