answersLogoWhite

0

Where is the oxygen sensor code p1155 located in Toyota mini van sienna?

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the bank one sensor two oxygen sensor located on a 2001 Toyota Sienna?

its is located downstream on the backside exhaust manifold


Toyota sienna bank 1 sensor 1 oxygen sensor?

bank 1 sensor 1 2002 on toyots sienna


Where is the vehicle speed sensor located on a 2000 Toyota Sienna?

location


How do turn off check engine light on 1998 Toyota Sienna?

must be a oxygen sensor


Will a Toyota Sienna oxygen sensor from an American car work on a Canadian car?

If the oxygen sensor fits the catalytic coverter and female vehicle port yes


Where is the vehicle transmission speed sensor located on a 1999 Toyota Sienna Van?

i have a 1999 Toyota seinna v6 and i will know where can i find the vehicle speed sensor.


Where is the bank 2 sensor 1 located on a 1999 Toyota Sienna po155?

Bank 2 is the sensor opposite from the number one cylinder, and on your vehicle is the front of the engine. Sensor 1 is the first oxygen sensor you come to from the engine in the exhaust pipe.


Can you drive your 2000 Toyota Sienna with a bad oxygen sensor?

can you safely drive a 2000 camery with bad sensors


Where is O2 sensor Bank1 sensor 2 Toyota Sienna?

The O2 sensor Bank 1 Sensor 2 on a Toyota Sienna is located after the catalytic converter on the driver's side of the vehicle. It is typically found along the exhaust system, near the rear of the engine. This sensor monitors the oxygen levels in the exhaust gases, helping to optimize fuel efficiency and emissions. Accessing it may require lifting the vehicle for better clearance.


Where is located the coil on Toyota Sienna 2001?

2002 toyota sienna electroni coil located


Where is the chassis number located in Toyota Sienna?

where is the classis location for toyota sienna


Where is the knock sensor location on a 2004 Toyota Sienna?

Sienna's have two knock sensors located in the valley underneath the intake manifold. Replacement is a three hour job.