yea, same size
It is unknown how many manual Sc300's were made each year; but Lexus reported 2000 on the road in 1997' -Granville the Lexus man.
It's for better traction in the snow.
Junkyard, E-Bay, Stealership
i have a Lexus coup sc300 year 1992 i need a engine and my intake manifolds are bad
You can obtain a vacuum diagram for a 1992 Lexus SC300 from several sources. The vehicle's service manual, often available for purchase online or at auto parts stores, typically includes detailed diagrams. Additionally, automotive forums, enthusiast websites, and platforms like Lexus or SC300-specific groups on social media may have shared diagrams or can provide guidance. Lastly, websites like eBay or Craigslist might list service manuals or repair guides that contain the information you need.
I believe the fuel pump is underneath the back seat, and the back seat needs to be removed to access it. This is not difficult, but does require 2 people.
To replace the rear speaker on a 1992 Lexus SC300, first, remove the rear seat and any panels or covers obstructing access to the speakers. Disconnect the wiring harness from the old speaker and unscrew it from the mounting location. Install the new speaker by securing it in place, reconnecting the wiring, and then reassemble the seat and panels. Ensure everything is properly connected before testing the new speaker.
To replace the AC compressor on a 1992 Lexus SC300, first, disconnect the negative battery terminal and relieve the AC system pressure. Remove the drive belt, then disconnect the electrical connector and refrigerant lines from the compressor. Unbolt the compressor from its mounting bracket and install the new compressor, reattaching the refrigerant lines and electrical connections. Finally, recharge the AC system with refrigerant and reconnect the battery.
thier should be a tensioner pully with a 5/8 bolt on it on the front of the motor if not i don't know
Yes... it backwheel drive so your tire size should be 245/35/20... they might rub a little when you have a few people in the car...
set the harmonic balancer pully to zero there are 2 notches on the cam shaft pullies that should align with a mark on the mounts