The thermostat on a 1993 Mazda 929 is located on the top of the motor just before the manifold covers. Look for the largest hose coming from the radiator at the top and trace the length of the hose back to its connection to the motor and the thermostat is at the point the hose connects to the motor.
The thermostat, on your 1992 Mazda, can be found on the front bottom portion of the engine. You can follow the water hose from the bottom of the radiator to the thermostat.
you have to remove the dash and every thing attached to it. Is it the same for a 1988 Mazda 929?
WHERE IS THE FUSE BOX IN MY 929 MAZDA AND WHERE. HOW DOES THE ENGINE CHECK LIGHT LOOK AND LAST WHY IS IT ON AND STILL RUN
Not getting fuel or spark?
In the engine bay. Infront of the stuts
Under the thermostat housing
waste of time
The thermostat for a 1995 Mazda 929 is located in the engine compartment, specifically at the engine's water outlet housing. To access it, you typically need to remove the upper radiator hose, as the thermostat is situated underneath this hose. Make sure to drain the coolant before attempting to replace it to avoid spills.
On a 1993 Mazda 929, the bleeder valves for the cooling system are typically located on or near the radiator and on the engine, specifically around the thermostat housing. You may also find a bleeder screw on the heater core lines. To bleed the system, you can open these valves to release trapped air after refilling the coolant. Always consult the vehicle’s service manual for exact locations and procedures.
The Thermostat is located at the low side radiator hole housing ( one end of the hole is connect from the radiator and the other end is connect to the housing
I have a Mazda 929 (1993) I had the same problem last year...I got a new alternator, and some new wires and spark plugs. Haven't had a problem with it since.
What is a timing cover seal on a 1992 mazda 929 and where is it located at?