On a 1991 Acura Legend, the water pump is located on the front of the engine, typically on the driver's side. It is driven by the timing belt, which means you'll need to remove the timing belt cover to access it. If you're planning to replace the water pump, it's also advisable to replace the timing belt and tensioner at the same time for optimal maintenance.
how to replace a water pump on a 1991 acura legend
The 1991 Acura starter is located near the front of the engine, on the left-hand side. You will find the starter near the bottom of the engine.
The map sensor for the 1991 Acura Legend is mounted on the firewall. It is in a box near the factory strut brace.
under the back seat
The 1991 Acura Integra idle air control valve can be found on the firewall. The valve will be on the drivers side of the firewall.
The 1991 Acura Legend starter is located on the right hand side of the engine, near the front, at the bottom. You can follow the positive battery cable from the battery to the starter.
it is located on the firewall side of the engine to the left of the oil filter
Should be located inside transmission pan.
The 1991 Acura Legend does not have an oil temperature sensor. It does have an oil pressure sensor. The oil pressure sensor will be located on the left-hand side of the engine.
how to install a altinator on a 1991 acura integra
The camshaft position sensor on a 1991 Acura Legend is located at the back of the camshaft, near the rear bearing cap. It monitors the rotation of the camshaft and relays this information to the vehicle's computer.
http://wiki.answers.com/Q/Where_are_the_fuses_for_the_1992_acura_legend_driver_and_rear_windows lokethed an the 1991 acura legend