0
What else can I help you with?
Where are the timing belt marks for a 95 Buick Skylark 25 liter?
iknow were the crank marks are but not the cams
How do you line up the timing marks on the camshafts of a 2001zx2 2.0?
Get bar that fits in slots on end of cams. The bar fits the cams only when at correct timing. At least this is how on 98
Where are the timing marks for a 2.0 16 valve overhead cams Mitsubishi engine in a Hyundai sonata?
The timing marks, on your Mitsubishi engine, can be found on the front main pulley. The timing marks will be on the outside edge of the pulley.
Where are the timing marks on a 1.5 in a 1982 Toyota tercel?
Timing marks are located on the camshaft of a 1982 Toyota Tercel. The timing marks help correctly align the cams so the cars engine can run properly.
Where are the timing marks in a Mitsubishi 3000 gt?
If you look on the sides of the cams and the puleys that involve the timing belt you should see little white dots. that indicates the marks.
What are the timing marks for a 1999 Mercury Mystique 4 cylinder?
The timing marks are on the crank pulley and oil pan. You have to line them up and also line your cams up.
Timing marks on a 2.5 dci Renault?
no you need timing tools put a timing pin in the block to lock the crankshaft and use the timing tool to lock the cams
Where is the timing sensor on a 1999 ford escort gt?
There is no suck thing as a timing sensor. The timing marks for a escort are not on the cams you must use a straight edge.
Where do you set the timing marks on a 2000 daewoo?
the two cams must be at 12oclock and the crank must be at 6oclock
Where are the timing marks on the cam 94 Mazda 626 v6 engine?
i have a mazda 1994 626 v6 24 valve car and i think the timing belt just broke where are all the timing marks crank shaft and cams?
Picture of timing belt marks for 2003 Mazda protege 2.0 dohc?
put cams dot to dot
How do you align the cams and crank on 1997 Kia Sportage 20 4 wheel drive?
there are marks on the timing cover that remains attached to the block and there are arrows on the cams. there is a pointer down by gear on crank and a dimple on gear align these marks
