0
Because of the age of the vehicle I'm going to make an educated guess that the most likely cause is that the cooling system thermostat has probably failed. (they always fail safe - in the wide open position which keeps the coolant overly cooled and thus unable to transfer heat into the heater) I agree.
What else can I help you with?
Will a starter from a 1999 Honda Civic ex work in a 1999 Honda Civic si?
Yes, it is the same starter for both.
Heat doesn't work in Lincoln ls?
my heat doesnt work in my2000 lincoln ls what causes this
How come the needle goes below the middle of the thermostat in the 1999 Honda cr-v?
In the "Normal" range? Lower than normal could be a bad thermostat Does heat work?
Why doesnt the heater work in 1999 Nissan sentra?
because it's broke
Why doesnt heat work in 96 Dodge Intrepid?
could be a sticking thermostat.
Does the rims on a 1999 Honda odeyssa fit 1999 Chevy suburban?
Not hardly, It will not work. Wheel stud patterns are different.
1999 wranglers heat only worked on high and now it won't work at all?
the 1999 wrangler's heat only worked on high,but now it don't work at all.
1994 Honda civic blower motor does not work?
if it doesnt work on 1 and 2 it could be a blower motor resistor but if it doesnt work at all check the fuses, relay and check voltage if it reads 12 v replace the motor
How does a pool heater work?
A pool heater typically uses either gas or electricity to generate heat, which is then transferred to the pool water through a heat exchanger. The heated water is circulated back into the pool to raise the overall temperature. The heater can be adjusted to maintain a desired temperature setting for the pool.
Have a 1999 Honda Civic with blown motor bought 1995 motor 1.5 will it work?
it has a moter
What is wrong if my heat doesnt work in my 2000 ford focus?
Check to seee if it has anti freeze.
Power door does not work Honda civic 1999?
When power doors fail on a 1999 Honda Civic there is a problem with a actuator or wiring. The door lock fuses should be checked. If the fuses are fine then the actuators themselves will need to be checked.
