0
Why would the newly replaced clutch on a 1997 Isuzu Rodeo not depress without a ton of force and actually feel like it is pushing back at a certain point?
Something is installed incorrectly. Most likely you did not install the "Pull clutch" properly. With a 1997 Rodeo clutch, the release bearing actually snaps into the ring in the clutch, and when the clutch is depressed the release bearing pulls the clutch, rather than the standard "Push clutch" model. So, when you are depressing the pedal, the clutch is not being pulled away, giving you the hard pedal feel. Make sure when installing your release bearing that you remove the small ring from the back of the connector ring on the clutch before you insert the release bearing, and then snap it back on after the release bearing is completely installed or the clutch will not work properly.
What else can I help you with?
How often does the timing belt on a 1999 Nissan pathfinder need to be replaced?
120,000 miles is pushing it i am told
If gravity is pulling you what is pushing you back?
Nothing. Actually gravity is pushing you down but there is enough air resistance on the earth to stop us feeling heavy and crushed
Will a floating object sink after pushing it down to certain depth?
no, it will float back to the top. try it in the bath
How are damaged panels replaced during the sliding technique?
As the old panel slides out the far end a new panel is added to the pushing end
Why are you burning out 2nd gear on a 98 Camaro LSI auto?
1 the transmission is old and needs replaced 2 the user is pushing it too hard
Is the 2nd tooth to the back fall out?
No. None of your teeth are supposed to be loose, except when the baby teeth are getting ready to be replaced by the permanent teeth, pushing them out.
How do you depress a calibour to get you rotors on on a Mazda 3 rear?
The rear calipers on the Mazda 3 have to be screwed in while pushing. The easiest way is to buy the $20 caliper tool from harbor freight. It's well worth the money and fits different cars.
Replace brake light in a Lexus es300?
The 3rd brake light can be replaced by removing the subwoofer cover by pushing down and towards the front of the car, other brake lights can be replaced by opening velcro covers on inside of trunk lid.
Can humans survive in space with only and oxygen mask?
No. Humans need more than just a supply of oxygen to maintain life in space. Because there is gravity on Earth, we are accustomed to this, and maintain our "shape" with the pressure of gravity, but if we went to space where there is no gravity, we would actually, explode. Because we are used to the pressure of gravity, our bodies are actually pushing out to keep shape, but once there is nothing pushing in, and we're pushing out, we explode.
Can you be diagnoised with fibromyalgia by a doctor pushing on you in certain spots?
Yes. There are certain spots that, if painful when pressure is applied, are indicators of fibromyalgia. This is why physicians press on those spots if they suspect you are suffering from fibromyalgia.
Who are the sisters on Pushing Daisies?
Vivian and Lily, although it is later revealed that Lily is actually Chuck's mother.
Steering wheel shakes when pushing on brakes?
This is a sign of a warped brake rotor. Have the brake pads replaced on both front wheels and have the rotors resurfaced or replaced if necessary. Make sure the lug nuts are torqued to the correct specifications. Rotors can warp due to excessive heat caused by heavy braking, driving with your foot on the brake, or over-tightening the lug nuts. There's actually several possible causes, its best to get a mechanic to check it out.
