0
What else can I help you with?
How would a steam locomotive turn itself off?
A a steam locomotive can turn itself off when the engine is overheated.
Olds achieva overheats a lot but this time the smoke is coming from the opposite side I turned it off so it could cool down but why would it not restart?
mine overheated a lot, turned out to be the heater core.
Why would there be pulsation on your brakes after you replaced pads and turned rotors on a 2006 Nissan?
CHECK WHEEL BEARINGS
MY moped's engine overheated because i had no water in it is it totally broke Because it wont start?
Not necessarily. I actually just overheated my air-cooled engine the other day. First, are you sure it is water-cooled? If so then more than likely you will need to replace certain parts in the engine such as piston, piston ring, etc. Or it would be cheaper to just buy a new engine.
Why would your 85 F-150 just STOP running after idling 10 mins or so?
You either ran out of gas or your engine overheated.
If an engine is cooked would it still run and if it was slightly under done what problem would you be getting?
Are you talking about an automobile engine or meat? Are you asking about an engine that overheated? Your question makes no sense. Ask it again and be specific as to what has happened, and any symptoms you are having.
Why would the brakes on a 95 chev truck pull to the right when applied the calipers are rebuilt pads new rotors turned brakes bled?
air still in lines. rebleed
What would happen if I drove my Hyundai Accent 2005 model with the hand brake pulled for about 2 kms?
Driving with the parking brake on wears the rear brakes. (Almost all cars have the parking brakes work on the rear brakes.) How much depends on how hard they were set and how far and fast the car was driven. It is possible that the rear brake system was overheated a bit, but in a mile or two it probably wasn't overheated that much, and it almost certainly wasn't worn that much, either. (How do the brakes work now? How do they sound? How do they feel?) A brake shop could probably tell in short order. Many of them do free checks on brakes. The experts there can provide some basic information about what may have happened. The concerned person would make a couple of phone calls and get the scoop from someone who does brakes for a living.
When a condition described as a pulsation when the brakes are applied what should be done first?
The first thing I would check or do would be to remove the rotors and check their condition. If they have enough surface left, have them turned to get them true again. If they can't be turned, then replace them with new (which should also be turned or at least checked .The most common cause of pulsating brakes, I have found, are warped rotors. This is usually caused from overheating.
Why would an engine shake in a 2002 dodge stratus when the car is turned on?
the engine mounts could be bad
Why would a Chrysler PT Cruiser stop running while driving?
Ran out of gas, failed fuel pump, water in the gas. Alternator, crank sensor, cam sensor, computer, coil, broken wiring. No oil in the engine and engine seized, overheated to the point of ruining engine.Ran out of gas, failed fuel pump, water in the gas. Alternator, crank sensor, cam sensor, computer, coil, broken wiring. No oil in the engine and engine seized, overheated to the point of ruining engine.
How do abs affect engine iddle?
ABS brakes should have no effect on engine idle, but a bad power brake vacuum booster would have an effect on engine idle.
