When Honda designed their V-6 engine they did not repeat one of the worst mistakes they made on the inline 4. On an inline 4 Honda, the alternator is stuffed between the engine and the firewall and you need to take apart half the front end to get to it. The alternator on a V-6 Honda is between the engine and radiator - very easy to get to. So...you unhook the battery, loosen the two bolts that hold the alternator in, pivot the alternator to loosen the belt, remove the wiring to the alternator, remove the two bolts, lift out the alternator...if the new alternator doesn't have a pulley move the pulley from old to new, then bolt it in leaving the two bolts loose for now, hook up the wiring, put the belt back on, adjust belt tension and tighten everything down good before reconnecting the battery.
how toreplace radiator in a 2001 honda accord ex four cylinder
how difficult is it to replace the MS on a 1996 Honda accord
How to change the alternator in a 1989 Honda accord lx
Have someone else do it for you.
Only if the battery fails the load test.
I just had my alternator replaced on my 1990 Honda Accord and the final bill was $315.
The PCV Valve is located in the Vaccum line above the alternator.
If the Master Cylinder is defective then replace it.
Yes, they are the same.
How do you replace a radiator on a 1991 Honda Accord
how do you replace the radiator on a 2003 V6 Honda Accord
The 2006 Honda Accord V6 has a timing belt and the 4 cylinder has a chain. Replace the belt at 110,000 miles.