A diplexer is a box that combines both signal usually mounted on the aerial mast . At the tv set another box separates the two signals,one to tv the other to sat digibox
A coaxial cable has great uses in television antenna connections. TV satellite connections also use coaxial cables to connect decoders to the TV set.
Satellite and terrestrial both use similar co-axial cables so it is probably fine to use a satellite cable for an antenna. If the cable needs to be extended, be sure to use a suitable 75 Ohm co-axial connector to make the joint. Twisting the conductors together and taping them will cause problems.
Install the antennae outside your home on the roof. Connect a coaxial cable from the antenna to the "ANT" port on the back of the Captive Works box in your house. Connect a coaxial cable to the "TV/VCR" port. Connect the other end to the television.
SMATV stands for Satellite Master Antenna Television. It involves using a central satellite dish to receive satellite signals and then distributing these signals through a coaxial cable network to multiple televisions within a building or complex. Each television can then access a variety of satellite channels without the need for individual satellite dishes.
Use an "RF Modulator". It has a number of inputs of various types (Coaxial cable, S-video, RCA-type A/V, etc.) with one coaxial output that connects to your TV.
no.
You will need a tv antenna and a coaxial lead in wire with connectors.
Most times they are the same but a satellite signal needs to be carried by RG6 cable it is a heavier gauge wire then say RG59. Regular or analog cable signal is sometimes carried by RG59 but digital cable should use RG6. +++ The primary specification is not conductor size but the impedance and capacitance of the cable.
A satellite antenna has one very important purpose. It is designed to allow a home to receive a satellite signal, which then allows users to receive a television signal.
To replace the antenna in a 1989 Mercedes-Benz 260E, first, remove the interior trim panel covering the antenna base. Disconnect the power and coaxial cable from the old antenna, then unscrew it from the mounting bracket. Install the new antenna by reversing the process: secure it to the bracket, reconnect the power and coaxial cables, and replace the trim panel. Ensure everything is properly connected and test the antenna for functionality.
yes because you are using the same radio frequency but as a portable device
An XM satellite radio antenna cannot be used as a cell phone antenna as they use a different type of connection. Satellite signals operate on a different frequency from cell phones and use different technologies in their antennas as well.