First, remove the power source, shot off the water then remove hoses (have a bucket ready to recuperate the water. In the top part of the washer there is 3 screws who old the top cover, remove them then slide the top out by lifting a bit. On the top of the drum, there is a blck hose going from the soap dispenser to the drum, remove the hose from the drum by squeezing it then remove from the soap dispenser and wash the hose. Turn the drum to arrive just over the hole where you remove the black hose (use a magnet screwdriver) , Slide your baffle by the front door then hold and screw by this hole on the top.
You can find Whirlpool Duet washer parts for purchase at authorized Whirlpool dealers, online retailers like Amazon or eBay, or directly from the Whirlpool website.
Yes!
removefourscrews
A Whirlpool Duet Steam Front Load Washer 4.5 cu. ft. is available for purchase online on the Amazon website. It is an energy star qualified washing machine and features advanced water and energy savings.
Get yo shoes and stuff them inside the washer,, and den press START!!The End!
A big red alien comes down from the sky and zaps your washer and then it spin drys!
The Whirlpool Duet washer door may not unlock due to a malfunction in the door lock mechanism or an issue with the control panel. It is recommended to unplug the washer for a few minutes and then try to unlock the door again. If the problem persists, it may require professional repair.
Whirlpool WFW8300SW White Duet Sport Front Loading Washer is a good enery efficient washer.
commuication error between ccu and mcu
Your Whirlpool Duet washer door may be locked and not opening due to a malfunction in the door lock mechanism or a problem with the control panel. It is recommended to unplug the washer for a few minutes and then try to open the door again. If the issue persists, you may need to contact a professional technician for further assistance.
To install a shock absorber for a Whirlpool Duet washer, start by unplugging the washer and locating the shocks at the front and rear of the washer. Remove the screws securing the shock absorber in place, then swap out the old shock absorber with the new one. Secure the new shock absorber with the screws and plug the washer back in. Run a test cycle to ensure proper installation.
There could be several reasons why your Whirlpool Duet washer won't unlock. It may be due to a malfunction in the door lock mechanism, a problem with the control board, or an issue with the power supply. It is recommended to unplug the washer for a few minutes and then try to unlock it again. If the issue persists, it may require professional repair or troubleshooting.