answersLogoWhite

0

You want to test resistance to see if there is a break in the windings. Set your voltmeter to Ohms.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Do component speaker have separate crossover?

usually they do but sometimes it will be built in to the main speaker


Where can one test drive Saturn Crossover?

A person can test drive a Saturn Crossover by visiting their local Saturn dealer. The person who is wanting to test drive the vehicle will be require to provide a legal driver's license before being allowed to test drive the car.


What kind of adapter does a home theater sub woofer use?

It's a CROSSOVER, they are almost always built into the speaker.


How do you use XTA crossover?

To use an XTA crossover, first connect the audio source to the input of the crossover unit. Then, set the desired crossover frequencies for high-pass and low-pass outputs according to your speaker specifications. Connect the outputs to the appropriate amplifiers or speakers, ensuring proper gain settings. Finally, fine-tune the crossover settings and levels for optimal sound quality during playback.


Factory amp location Chrysler town and country?

The factory amp is actually located on each speaker like a crossover.


What does a speaker-level connection to a subwoofer take advantage of?

The subwoofer's crossover network??? best match Roger S. 487


Is there any way to convert a sub-woofer into a speaker how?

A subwoofer is a speaker. If you want to know if is possible to convert it into a full-range speaker, then yes, it is. You have to add a tweeter and crossover to the box, but the complexity in doing this and the quality of the results will show that it isn't worth it.


How do you access the crossover in a Leak Sandwich speaker?

To access the crossover components in a Leak sandwich speaker: 1. Undo the nut in the centre of the rear panel - use a very large screwdriver to do this. 2. Unclip the front grille. 3. Undo the retaining screws of the bass driver. 4. Lift out the bass driver. The crossover components are now visible on the block of wood that fits between the rear of the bass driver and the rear panel of the enclosure.


Is the kef speaker iq5 different from the iq5se?

The SE's had an internal shelf / splitter removed to improve the bass responce and they tweaked with the crossover.


What is the crossover's function in a loud speaker?

A crossover separates the high frequencies from the low frequencies, usually around 2000Hz, so you can send the highs to a tweeter or smaller speaker and the lows to a woofer. For some reason it sounds better that way than sending the full audio spectrum to both speakers.


How do connect sub woofers to a Chevy Trailblazer factory radio?

you have to get an amp, crossover or an amp with a crossover built in and all the gear to install it like speaker wire power cable patch cords remote wire bow for the subwoofer that will fit the truck


How do you hook up a crossover to the amp?

To hook up a crossover to an amplifier, first, connect the output from the amplifier to the input terminals of the crossover using speaker wire. Then, connect the crossover's output terminals to the appropriate speakers, ensuring that the connections correspond to the correct frequency ranges (e.g., high-pass for tweeters, low-pass for woofers). Finally, ensure all connections are secure and double-check the polarity to avoid phase issues.