Just use it like an 8 ohm speaker or else connect two 16 ohm speakers in parallel to form an 8 ohm load. Parallel is positive to positive and negative to negative.
Xenyx 1204FX is not powered mixer. If your speakers are passive (don't have their own powersupply system), this means that you need to get an amplifier for them.
in parallel No. Two 8 ohm 'speakers in parallel present a 4 ohm load.
The 6 ohm speakers will sound fine with the 8 ohm amplifier.
The ohm rating is 8 ohm on the rear speakers in a Pontiac Sunfire. They can be switched out, as long as the front and rear speakers match.?æ
The front speakers should be 6.5" and the rear should be 6x9". You will want to make sure you have the correct ohm speakers though. My 2004 impala has 2ohm speakers and my friends has 4ohm speakers. You can put 4 ohm speakers in a 2 ohm system but your sound quality will suffer greatly. Do not put 2 ohm speakers in a 4 ohm system though, that will cause bigger problems.
Four 8 ohm speakers wired in parallel would give an effective 2 ohm load.
They are 6 ohm.
yes
they are probably 4 ohm
Yes
When connecting 16 ohm speakers to an 8 ohm amplifier, it is important to consider the impedance mismatch. This can affect the performance of both the speakers and the amplifier. It is recommended to use speakers with an impedance that matches or is close to the amplifier's impedance to avoid potential damage or distortion.
Cerwin Vega speakers can cost anywhere from $61.99 for a single VEGA084.2 8 inch series dual 4 Ohm subwoofer, to $1,500.00 for CMX-210 4-way powered loudspeakers.