answersLogoWhite

0

Unlock the car. Open the door. Get in. Start the engine and warm up to 10 mins. Drive it out to the driveway. Head for the highway with a speed of 50 mph. Turn in to the nearest workshop. Stop the engine. Roll down the window . Climb out from the car. Pay the dude there to do it for you. Simple as that.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Does proton gen 2 have a timing belt?

Yes.


How do you fit proton gen 2 door handle?

To fit a Proton Gen 2 door handle, first remove the old door handle by unscrewing it from the door panel. Then, align the new door handle with the screw holes on the door panel and screw it in securely. Test the new door handle to ensure it functions properly before reassembling the door panel.


Where about is the thermostat in a proton gen 2?

The thermostat in a Proton Gen 2 is typically located at the front of the engine, near the top, underneath the thermostat housing. This housing is connected to the upper radiator hose. It is important to consult your vehicle's manual or seek professional help when working on the thermostat.


How to remove a factory Bose stereo from 2001 Mitsubishi eclipse GS?

The mitsubishi eclipse has never had a bose stereo your 01 gs came with an infinity stereo, if your car does have one it is because it is aftermarket. To remove it you simply take the 2 screws at the bottom of the face plate that covers the heating and radio then remove the 2 or four depending how big your stereo is and pull it out.


How do you remove generator 1961 Ford Falcon?

disconest the battery,remove the bolt in the adjuster arm then take out the 2 bolts from the gen. to engine gen mounting bar


How do you remove the stereo in a 1996 Oldsmobile cutlass supreme?

On my 1996 Oldsmobile cutlass supreme it was very easy to remove the stereo. The entire plastic molding piece that surrounds the stereo as well as covers the speedometer is attached by some push clips and can be simply pulled off, no screws. Once the plastic surrounding is removed there will be 2 screws holding the stereo in place. Remove the 2 screws and pull the stereo out. Unplug the wire harness and antenna.


How do you remove stereo from Peugeot 806?

On a Peugeot 806 car stereo there are two thin pieces of black plastic at each side, you need to gently prize them off, and that reveals 2 screws on each side you can then remove the stereo. -Jakey5565


95-99 Monte Carlo how do you remove the stereo?

First you have to remove the plastic dash cover that goes around the radio, a/c vents, and steering wheel (it just pops off). there are 2 screws that hold the radio in, remove the 2 screws and pull the stereo oun and unplug.


How do you remove a stereo system from a 2004 Mitsubishi outlander?

pull all the knobs for your heater controls off, remove 2 Philips screws pull heater bezzel out (not off completely) then you can pull the radio bezzel off. remove screws and pull stereo out. infinity stereo the amplifier is under the drivers seat.


How do you remove a sONY stereo from a Toyota Paseo?

1. from bottom of trim panel around stereo pull from dash. 2. pull panel down to release latches at top. 3. remove 4 screws securing car stereo and pocket to dash. 4. pull car stereo forward, disconect antenna and connectors.


What idle speed should a proton gen 2 2006 have?

For manual transmission it's 950rpm and for Automatic it's 1050rpm This all been done with air cond etc off


How do you reset your proton gen-2 remote key?

To reset your Proton Gen-2 remote key, you can try replacing the battery and then programming the key fob following the manufacturer's instructions. If the issue persists, it may be necessary to contact a dealership or a locksmith specializing in automotive key fob programming for further assistance.