The only way to connect a 300W amplier to a 60W amplifier is in series. You would also need to carefully balance the inputs so that the two amplifiers would do exactly their assigned workload. Its not a good idea, however, because the distrortion from the 300W amp would likely overwhelm the capacity from the 60W unit. Besides, 60W is less than -6db difference from 300W. The human ear can only resolve differences of only +/- 3 db, so just ignire the 60W and go with the 300W. Any thing else is likely to wind up being the "distorted" noise that irritates us peace seakers.
You can put what you want but with a power rating of unlimited (there are protection circuit's) and an efficiency of 86db/1W/1m you should put at least 300W (real world watts) to them or the midranges will "pop".
Astm a-36
Safe, as in you're not going to electrocute yourself, yes.<br /> But, the amp will be able to put out more power than the speakers can handle, so don't turn the volume up all the way or you will fry the speakers.
It is unclear what you as asking about as fuses are rated in Amperes not Ohms. A fuse that measures 4 Ohms would be defective (not good but not fully blown open either).
Will a xfx nvidia geforce 9600gt xxx edition graphics card work on 300w power supply
A 300W plate most likely refers to a heating plate or element that has a power rating of 300 watts. This indicates how much electrical power the plate consumes when in operation, and can give an idea of how hot the plate can get.
A36 steel is a standard mild steel grade with a minimum yield strength of 36,000 psi, while 44W/300W is a Canadian steel grade with a minimum yield strength of 44,000 psi. The main difference lies in the yield strength, with the 44W/300W grade being stronger and more suitable for structural applications that require higher strength.
There is no power amplifier with 8 Ohms output impedance. Therefore the usual impedance of this amp is arround 0.1 ohms which is good for bridging your 8 Ohm speakers. Scroll down to related links and look at "Interconnection of two units - Voltage Bridging - Zout < Zin".
Yes. Peak power or max output is rubbish. You will never get clarity at a speaker or amp's max output. RMS is what it's all about.
Yes, that is normal.
I would use a 300W power supply for a 250W appliance. It's recommended to have a power supply that can handle more than the actual wattage of the appliance to ensure efficient operation and prevent overloading. In this case, a 300W power supply would provide enough headroom to safely power the 250W appliance.