In general, this part of the microphone is called the transducer.
For Condenser microphones, a diaphragm-like transducer is used.
For Dynamic microphones, either a ribbon-like or moving coil transducer is used.
The diaphragm
A microphone works like a tiny speaker in reverse! When you talk or make noise, sound waves travel through the air and hit a special part inside the microphone called a diaphragm. This diaphragm vibrates, turning the sound waves into electrical signals. Those signals then travel to a speaker or recording device, allowing others to hear your voice!
Latin word part phono--, which means "sound" and micro-- means "small"
-- a microphone -- the part of a telephone near your mouth
The ability of an organism, or part of an organism, to detect changes in the environment is termed as sensitivity. What is microphone sensitivity? A microphone sensitivity specification tells how much electrical output in millivolts a microphone produces for a certain sound pressure input in dB SPL. If two microphones are subject to the same sound pressure level and one puts out a stronger signal (higher voltage), that microphone is said to have higher sensitivity.
The picture part is called VIDEO, the sound part is called AUDIO.
The part of the bell that makes the sound is called the clapper. This is the hanging piece inside the bell that strikes its sides to create the ringing sound.
The function of the neuron part that picks up signals from other neurons is to receive and integrate incoming signals, allowing the neuron to communicate with other neurons and process information. This part is called the dendrite.
For the most part, it's the Line In. It's "equivalent" to the "AUX" port on other devices. It allows audio in from devices that is not a microphone.
Yes, you will need a microphone to talk. It is the instrument through which your voice will pass. The microphone is an essential part of talking.
The tranducer/microphone converts the vibrations of the waves into electrical audio signals, the vibrations cause a diaphragm inside the transducer to vibrate which in turns create pulses of current that can be interpreted later as the recorded audio.
The microphone. Usually at the bottom.....