answersLogoWhite

0

Adding a question mark after a statement?

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Will a 1985 Chevy Celebrity transmission fit a 1991 Buick LeSabre?

Will the transmission from a 1985 Chevy Celebrity fit a 1991 Buick LeSabre


Do a 1985 Buick LeSabre and a 1986 Buick LeSabre have the same doors and are they exchangable?

No they are not, 1985 is rear wheel drive & 86 on is front wheel drive.


What is the firing order for a 1985 Buick Lesabre 5.0L?

The firing order for a 1985 Buick LeSabre 5.0L is 1-8-4-3-6-5-7-2. This same firing order is used throughout the 1982-1985 Buick LeSabre's with a 5.0L engine.


How many 1985 Buick LeSabre Limited collectors Edition were Manufactured?

500


How many gallons of fuel does a 1985 Buick LeSabre hold?

Approximately 25...


How much does a 1985 Buick LeSabre Collector's Edition weigh?

Look on the driver's door post.


Is there a Caprice Classic that would be compatible with a 1985 Buick LeSabre?

No, these are likely completely different platforms, though I can't recall when the LeSabre went front wheel drive. If the engine is transverse, there are no compatibilities with a Caprice.


How do you remove the dashboard face to swap out the old stereo in a 1985 Buick LeSabre Collectors Edition rwd land yacht?

U grab the dash Bezel or face & pull .


How to set clock on 1985 Buick LeSabre?

If I remember correctly, you have to pull out the radio buttons that don't correspond to #1 through 6. Hold it out for a while and it will begin to change the hour or the minute.


Why would the turn signals go out on a 1985 Buick LeSabre when it rains?

you may have a short in your wiring where it direclty shorts to ground when the wire gets wet. track you wiring and you will probly find a break or rip in it.


Where is the horn located on a 1985 Buick skyhawk?

where is the horn located in a 1985 buick skyhawk


How do you replace the heater core in a 1985 Buick LeSabre?

To replace the heater core in a 1985 Buick LeSabre, start by disconnecting the negative battery cable and draining the coolant from the radiator. Remove the dashboard to access the heater core; this involves taking out screws and clips securing the dash. Once exposed, detach the heater core from the heater box by removing the inlet and outlet hoses, then replace it with the new unit, reassemble everything, and refill the coolant. Ensure to check for leaks after completing the installation.