I just snugged mine down, no problems 30k later
On a 1995 GMC Jimmy with a Vortec engine, the fuel injectors are located within the intake manifold, specifically under the upper intake manifold assembly. To access them, you typically need to remove the air intake assembly and the upper intake manifold. The injectors are mounted directly to the lower intake manifold and are connected to the fuel rail, which supplies them with fuel.
Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.
From 1995 Aurora Service Manual page 6A8-20/Lower Intake Manifold. Tighten the intake manifold bolts twice to 10 N*m (88 lb. in.) following the sequence in Figure 29. -----3-----1-------5 -7-------------------9 8------------------10 ---4--------2-----6
Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.
its right on the back side of the manifold at least it is on my 1991 gt beretta it like bolts right into the back of the intake manifold. Scott Welker
under the intake manifold
Under your intake manifold. Its a pain to change them, so do them all and clean out thee egr valve too. it is also under there.
There is no difference,,,
i am replacing the starter on olds 1995 aurora
The intake manifold is underneath the plastic silver cover held down by four nuts. Take it off and you'll find the intake manifold - also plastic. Even more unusual, the starter is underneath the intake manifold!
you must remove upper intake manifold to access these plugs
It's on the intake manifold.