0
1996 Mazda Millenia wouldn't start got a jump but when I took battery cables off the engine died?
Don't know about this issue re: Mazda.... but all other cars will cut off when the battery is disconnected, if the alternator is dead (bad). In the olden days, the alternator was called a "generator". That's because it continuously generated power for lights, horns, etc. That "generator" regenerates/recirculates power to keep the car cranked, but when you turn on your lights, the generator cranks out more power for the extra load. With a bad generator (alternator), your car's system does not have enough amps to keep the system running.
What else can I help you with?
How do you reset the service engine light on a 2002 Mazda mellinia?
I have a 2002 Millenia-S and removing and reattaching the + battery cable does reset the check engine light.Answertry unhooking the positive cable to the battery...this works on my 97 millenia
How do you connect the battery to the coil to start a honda cd175 engine out of the frame and on the bench?
Just connect the battery to the motorcycle battery cables with jumper cables and then start it.
How do you Replace battery cables 92 ford ranger?
Remove cables from battery Remove + cable from the starter solenoid Remove the - battery cable from engine ground install new cables using the same routings as original
What liter engine is in Mazda millenia 2001?
The millenia P - has 2.5 liter engine, The Millenia S has a 2.3 liter engine
What are the symptoms of a bad battery or cables?
The symptom of a bad battery or cable is the starter is unable to get the power to start the engine. You can use a digital multimeter to check to see if it is the cables or test the battery for the definite cause.
Reset the service engine soon light 98 Tahoe?
A person can reset the service engine light in a 1998 Tahoe by disconnecting the battery cables for 1 minute. After the battery cables are reconnected, the light should turn itself off.
How do you change the battery cables on a 1990 Olds Cutlass Supreme 3.1 engine?
disconnect cables from battery. follow pos. cable to starter and disconnect. follow neg. cable to end disconnect bolt mounted to engine. good luck. hamsandwich
How do you replace the battery cable on a 1988 Ford F250 truck?
Disconnect and remove existing cables Replace with new cable using the routing used by original cables + from battery to starter solenoid - From battery to good engine ground
Car wont start after replacing battery?
Replacing battery terminals??? How did you accomplish that. Do you mean you replaced the battery or are you referring to the battery cables? If you replaced the cables are you sure you have them connected correcty and tight. Especially the ground connection. Take a reading with an ohm meter from the neg battery post to the engine or chassis. If the circuit is open, you have a bad connection.
Why do you need a second battery to start your 350 4-barrel engine when it is hot?
Weak battery, weak starter, resistance in the battery cables, ignition timing,
What would cause a clicking noise only when lights are on and engine does not start?
Weak battery? Loose or corroded battery cables? Starter solenoid?
How do you replace spark plugs on 1997 Ford club wagon?
Disconnect the battery, remove the engine cowl, remove the spark plugs cables, boots and plugs on the drivers side of the engine, replace with new spark plugs and attach the boot and cables. Do the same on the passenger side of the engine, replace the engine cowl, and connect the battery.
