answersLogoWhite

0

There is a small round moulded mark in the plastic directly below the ignition switch. Originally was for a button in early design but was removed from the plan. look very close with a flashlight and you will see the outline. However it still marks where the ignition cylinder has a button that will allow the key to release and you can turn it back to the off position and remove it. If you have a small drill or dremel you can open this fake plug and reveal the button. I used a dremel to open it up big enough to put my finger in and press the button. I use it every day .... until I decide to spend the money and buy a new ignition switch.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Your gmc envoy won't start and key is locked in ignition?

My 2002 GMC Envoy won't start,no lights come on when trying to jump start the battery. And my key won't remove from the ignition. What's should i do?


Your key is stuck in the ignition in your 2003 GMC Envoy is there a key release button?

My envoy did this also when the battery died. installed new battery and key came out.


Why does your 2003 GMC envoy not crank when you turn the ignition The battery is fully charged?

Check the starter.


How do you change spark plug in gmc envoy?

To change the spark plugs in a GMC Envoy, first ensure the engine is cool and disconnect the negative battery cable. Remove the ignition coil by unscrewing the bolts and gently pulling it off the spark plug. Use a spark plug socket and ratchet to unscrew the old spark plug, then install the new one by hand to avoid cross-threading, followed by tightening it with a torque wrench to the manufacturer's specifications. Finally, reattach the ignition coil and reconnect the battery cable.


How can you get a coin out from the steering wheel on a GMC Envoy?

Unplug the battery then start dismantling the steer wheel. The airbag will not deploy if the batt. disconnected. You need a GMC coin remover, I have one I will sell for $60.


Why can't i get my key out of the ignition on my 2002 GMC envoy?

Defective, worn, ignition tumbler.


How do you remove fan shroud on 2004 gmc envoy?

How do you remove the fan shroud on a 2004 get envoy


How do you remove 4x4 switch 2007 gmc envoy?

how do you remove 4x4 switch on a 2007 gmc envoy


Where is the oil sensor locate on a 2004 GMC envoy?

On a 2004 GMC Envoy, the oil pressure sensor is typically located on the engine block, near the oil filter. It can be found on the driver's side, positioned towards the rear of the engine. To access it, you may need to remove some components or use a socket wrench to reach it effectively. Always ensure the engine is cool and the battery is disconnected before attempting any repairs.


What makes the battery light stay on in 2003 GMC envoy?

From what I have been reading, it is a faulty ignition switch. Looks like it has happened to several people too. It can also be the alternator is defective.


Where is the idle air control valve on 2005 envoy?

The idle air control (IAC) valve on a 2005 GMC Envoy is located on the throttle body, which is mounted on the intake manifold. To access it, you'll need to remove the air intake duct and possibly other components that obstruct the view. The IAC valve is typically attached with screws and has an electrical connector. If you're planning to replace or inspect it, ensure the engine is cool and the battery is disconnected for safety.


Which battery does a GMC 04 Envoy use?

group 78--6 year battery